Weedeater Carburetor Rebuild & Fuel Line Repair Part 2 of 3
Loading...
Loading...
50,220
Loading...
Uploader Comments (donyboy73)
see all
All Comments (38)
-
i need a k 20 wat kit
-
That little Walbro adjusting tool doesn't look exactly flush to me... is there any way you can measure the exact displacement? Thanks! I terribly appreciate your videos!
~Alexhb
-
@axlsavage there's a little retainer around both screw caps that needs to be spread out then pull them off with needle nose pliers
-
Hello, geat vids! I have a question, I have a troybilt weedeater with a zama cq1 carb. I cant figure out how to get the adjuster caps off the carb. I tried just pulling on them but no deal. Any ideas? Thanks again for the great vids!!! Chris
Loading...
9:54
Weedeater Carburetor Rebuild & Fuel Line Repair Part 3 of 3by donyboy7354,789 views- 5:51
Weedeater Carburetor Rebuild & Fuel Line Repair Part 1 of 3by donyboy7373,833 views
- 5:56
HOW TO ADJUST The Carburetor on Weedeater XT260 Grass Trimmerby donyboy7364,664 views
- 4:50
Fuel Line & Filter Repair on Ryobi,Troybilt, MTD 4 Cycle Grass Trimmerby donyboy7320,754 views
- 6:21
How to Replace Fuel Lines on Two Cycle/Two Stroke Enginesby eReplacementParts80,705 views
- 5:07
how does a 2 stroke carburetor workby warezvz51,786 views
- 2:13
Homemade Chainsaw Bike ( Not Friction)by Ankeladden127,080 views
- 6:49
Small Engine Repair: Checking Fuel Pump Diaphragm & Inlet Needle on a Diaphragm Carburetorby smallengineshop32,670 views
- 7:19
How to Diagnose Two-Cycle/Two-Stroke Enginesby eReplacementParts2,695 views
- 10:07
My temperamental Weedeater featherlite trimmerby wtam692,569 views
- 1:38
Starting a Chainsaw!by boomboomPOW94,190 views
- 13:05
How to Rebuild a Zama Carburetor- Echo Backpack blower carbby th1994030519,550 views
- 9:16
Tecumseh carburetor rebuildby mbyr3171,918 views
- 4:28
Installing AN Hose Ends the easy wayby Speedsourceusa2,913 views
- 4:15
FL20 FUEL LINES REPLACEDby AllSmallEngines16,251 views
- 2:24
Weed Eater Repairby 30GB6,625 views
- 9:58
HOW TO REBUILD Carburetor on 4-5HP Tecumseh Snowblower Engine Part 3/3by donyboy7319,596 views
- 3:48
quim barreirosby anfalz23,675,731 views
- 7:36
How to clean a weedwacker carburetorby TheRealOutdoorz22,378 views
- 4:30
How to Sharpen Hedgetrimmer Bladesby eReplacementParts31,332 views
On the back plastic engine cover, what type of gasket should I use?
the stuff in a tube?
what kind of stuff in a tube?
Mrengineerwannabe1 2 months ago
@Mrengineerwannabe1 you can use permatex rtv silicone or permatex moto seal
donyboy73 2 months ago
where do u get the kits
pito45720 4 months ago
@pito45720 u could get them at mowers4u dot com
donyboy73 4 months ago
Excellent video, your level of explanation is very appropriate for us modest DIYers to get it right. In fact your tip about bending up the metering lever up to enrich the mixture is just what I needed to do to fix my problem. The Walbro kit-supplied part had the lever arm so low that I don't think the needle hardly moved up. When trying to accelerate above idle, the trimmer would die out. Eyeballed lever to above the plane a bit as you show in the video and presto - fixo. Thanks so much.
bigsteamdave 6 months ago
@bigsteamdave thanks for watching
donyboy73 6 months ago