CLaNZeR Looking at the McNutt Magnet Motor Claim Part 4

A carry on from the other 3 videos on the McNutt Magnet Motor.

David McNutt got in touch via email and sent a new plan.

A new rotor has been cut out today and populated with 40 magnets .

Here is initial tests

Category:

Science & Technology

Tags:

• McNutt
• Magnet
• Motor
• Free
• Energy
• Overunity
• Steorn
• Orbo
• Clanzer

[JackDepp8989]

Excellent Design....

If you want to get the Plans for the Free Energy Generator

Go to Google and have a Search for "Best Magnetic Generator Review"

Choose the First Results (Remember to Skip the Advertisements)

[120dbdavid]

Make outer ring cut into three pieces two or more magnets per each adjustable section mount and adjust. Your design can use 12 magnets per section

[TheKaos90]

@Thelbatrop No no , you could add a low power motor that provides just enough energy to get past the low energy zones , allowing the rotor to gain energy from the high energy positions = overunity ; now we're in business :D

[Thelbatrop]

Dont you see? The harder you spin the plate, the longer it will take to stop. You can only use the overunity energy by attaching a battery to it, which will be charged by the spin of the plate and then at a specific point emits some energy to spin the plate again.....

What do you think?

[McNuttMagnetMotor]

very astute overunitydotcom :)

But same can be done with compressing the flux field ie close to cancel the flux changes in the small rotor field but I'm posting new drawing with more power and much stronger field and flux alignment.

Thanks for the support and keep on watching :)

David

[overunitydotcom]

Hi Clanzer,

without the right iron core pieces around the magnet for 90 degrees asymmetrical flux redirection you will never get a magnet motor to work just with magnets.. YOu need the iron for

flux redirection and magnetic viscosity.

Hope this helps.

Regards, Stefan.

[McNuttMagnetMotor]

Buying tools so will take a bit of time for me to make a new one.

Thanks Clanzer for the work btw all my fault for the lack of drawing.

David

[McNuttMagnetMotor]

This is to repeat my first model to show full rotation(concept).

Clanzer has differently done more prototyping testing and video documentation than myself.

I stopped work after one of my attempt's broke free and shattered some magnets.

I am trying to get access to machining to continue my work.

I'm on disability so my funds are not sufficient to let me get my own items machined yet.

Thanks to Mr. Clanzer for his work and understanding.

I do hope this helps to clear up what we are doing.

[tpbulle]

Kinda seems like mcnutt has an idea only and is looking for guinea pigs to test and develop.

You have apparently done more prototyping testing and video documentation than he has done.

This following an all too familiar pattern.

Very nice work as usual Clanzer.

[Cloxxki]

Could or has David shared a video of any of his working motor, however dodgily built?