Mudbog 84 F150 300I6 4spd
Loading...
Loading...
4,004
Loading...
0:50
Ford vs Chevyby bkeith26920,999 views- 0:21
2.3 Turbo Mustang In-Car Powershiftingby 2300gearjammer7,678 views
- 1:02
93 F150 300 0-60by lightsy20105,881 views
- 1:16
1991 F150 300 I6 top speedby doug1bite6,707 views
- 2:17
my 1984 ford f150by farmallboy89894,962 views
- 1:11
1977 Ford F100 300 Inline 6 Twoby Orttymonster14,832 views
- 1:44
Ford 300 I6 Modded w/Flowmasterby fiftyfordfloored24,441 views
- 0:54
1981 Ford Bronco 300 Straight Six new exhaustby milesaway198010,056 views
- 0:56
FLOWMASTER SUPER 44 EXHAUST.movby BIGBLUEFORDF15017,200 views
- 1:24
f150 4x4 mud truckby impolois33,610 views
- 0:24
Blue Ford on 44's, part 2by originalclownboy118,075 views
- 2:40
Frankinsixby DandAmachine25425,289 views
- 1:18
F150 4.9L 300 i6 Straight Six Flowmaster 40 Exhaustby saxbros48,183 views
- 2:08
F150 Going Through Some Mudby 07buicklucerne857 views
- 0:21
2000 f150 in a mud holeby gityermudon3,009 views
- 1:36
Ford 300 I6 Built & Modded w/custom Gibson exhaustby fiftyfordfloored18,779 views
- 1:09
1984 Ford Bronco 300 4.9 I6 Holley 600 CFM 4bbl with headersby milesaway19805,374 views
- 2:04
1980 f150 stepsideby ShaneNeilPhillips1,784 views
- 0:31
1984 Ford Truck Commercial with Irlene Mandrellby takutaq59,005 views
@KeepItRoostin658 There are write-ups out there on the net on how to do it properly. I didn't do it as I didn't really care what happened to the truck. The clutch acted shitty for a long while afterwards and I killed a starter in the process of doing this dumb shit.
turbomoore 10 months ago
@turbomoore how can you waterproof your bell housing?
KeepItRoostin658 10 months ago
And fyi: DO NOT mud without water-proofing your bellhousing! I had clutch problems after this was made and it trashed the starter.
turbomoore 2 years ago
The lift is homemade. I made brackets to drop the pivot points of the beams down a few inches. I bought a steering box arm for a lifted F150 and made spacers for the springs and shocks. The rear is just a block kit but I did have to make a drop-down spacer for the 2 piece drive shaft. There is no exhaust. I just couldn't justify spending any money on the truck. I wish I could've made that run AFTER the LSD went in and the better tires went on...it would've went to the end. :-)
turbomoore 2 years ago
haha i have the exact same truck as this? can u tell me if u put and kinda lift in the truck and what did u do for the exhaust?
TheWarMachine93 2 years ago