Zune 120 Repair: How to Replace your Zune 120GB Battery
Loading...
3,776
Loading...
Uploader Comments (BadGizmoRepair)
see all
All Comments (9)
-
fuck u microsoft
-
I've checked and rechecked, the solder is not touching each other. They're all in the correct place and the zip cord is back in place. I can't figure out what went wrong.
-
I'm trying to pry apart the front and rear panel and I can't seem to get in between them. I noticed in the video that you already have a bit pried open...Could you give me a tip on how you did that?
-
just for clarification, this technique works for the 1st generation 120 gb zune? i've had mine for 4 years and the battery finally died.
Loading...
I hate to say it, but this didn't work for me. I used this and the tutorial on the badgizmodo website and by the end, my zune 120 failed to start up. It also made a sizzling noise which i think was a short circuit when I tried to touch the black wire to the already soldered section after the other 3 wires were on. I wish this tutorial would have been a little more specific on the to do's and the to dont's.
j9qw 2 months ago
@j9qw Make sure that none of solder points are touch each other this will cause it to not power on.
BadGizmoRepair 2 months ago
Thanks, helped a bunch, just replaced the battery on my mom's 2nd gen 120gb Zune. Everything works like a charm.
ggfb20 4 months ago
@ggfb20 thanks we should have an updated version up sometime soon! Make sure you check out BadGizmo.com
BadGizmoRepair 4 months ago