too much carrier preload
Loading...
Link to this comment:
Top Comments
All Comments (30)
-
I can guarantee you that you would be pulling the gear set and replacing it withing a few thousand KM's if you ran it like that. :P
Great style video for the young guys with A.D.D. though.
-
you shouldn't be able to turn it that easy
-
@jayguy173 It shouldn't spin completely free.
-
@jayguy173 Diffs aren't supposed to spin comepletly free.
-
...What was the point in watching this...
-
This is too little preload. With the proper preload you shouldn't be able to spin the ring gear by hand at all. This video is an example of too little preload. It should have 15-28 in. lbs and the ring gear in this video may not even have 5 in. lbs. Accomplishing this amount of torque is a PITA. I used a 18 inch breaker bar with 3 feet of pipe. It is doable but not easy.
-
means a strong decel
-
YOUR LEFT HAND IS A HOOK
7 months ago 7
-
sounds like bad carrier bearings . Also is there a pinion gear installed?? turns too easy
-
Its a bit loose the pinion need to have 15-25 lbs of peload on it so the bearing stay well set .
- 0:08How to break a diff.by morgish109,358 views
Featured Video
- 0:16not enough carrier preloadby cellularmitosis98,722 views
- 0:11carrier preloadby cellularmitosis51,551 views
- 0:56Getting Curly's Diff Weldedby gwesproductions52,133 views
- 0:11noisy gearsby cellularmitosis153,184 views
- 3:00SARAH PALIN"S DAUGHTER LIKES uncle joey's FANal...by kushtv1,907,965 views
- 0:35transfer case problemby waldronjs36,437 views
- 4:23How To Replace An Oxygen Sensorby canobd233,234 views
- 2:24Dana 35 Spartan Locker Installation.wmvby Baseline4x4Outfitter68,443 views
- 4:51How To Install Repair Replace 4WD Transfer Case...by 1aauto19,037 views
- 14:22How to replace your Front pinion bearings on yo...by briansmobile16,095 views
- 6:40transfer case problem 2by waldronjs22,370 views
- 0:21Jeep SRT-8 426 Whipple LAUNCH!by fastviper777237,113 views
- 0:16Burn out goes badlyby avro2061,796,168 views
- 1:21pinion noiseby aakjose75,734 views
- 0:40BAD REAR ENDby cdqickgt262,122 views
- 29:24Differential Ring and Pinion Gear Setupby WeberAuto36,099 views
- 0:40Removing or Installing a Ring and Pinionby franklandracing45,972 views
- 1:43Test of diff gears after replacing shims behind...by meestahwah13,542 views
- 0:56Lockers.... are NOT over ratedby Burnout850661,860 views
Neato... I like it when short videos with no editing are interesting enough to hold their own.
BlindDogFulton 3 years ago 20
adjust it until it just spins freely
jayguy173 2 years ago 8