Installing tail servo on a trex 450
Loading...
14,751
Uploader Comments (GaryGraham66)
see all
All Comments (6)
-
Thanks Gary
-
Hi, use a tiewrap (cable tie) and slid it under the guide at the top, cut off the excess either side and you're good to go (c:
see my build video on the trex 450 sev2 at 7 mins 20 secs.
-
How did you secure the plastic control rod guides? the ones on my 450se are a bit loose on the tail boom. Did you use super glue?
-
Not an expert but the best place for a 'tail'-servo is on the left !! This is to minimize damage from rotorblades chopping up the servo....in case of a crash.
-
Hi, thanks for the comments, the servo is a Futaba s9650, quite a popular servo for the tail and works well with the GY401 gyro.
-
Thanks for another great video. Type of servo used?
Loading...
yes GARRY i have now trex sa. so when low stick they have to look down all of them and middle linear..? and can you tell me please the throttle curve and pitch to set my heli properly??!!! my swash is 3 servos 120de. thanks a lot Garry for your help!!
cypriotkikos 2 years ago
Hi, set up servos with pitch curve, 0 25 50 75 100, the throttle curve does not matter.
with the throttle stick at 50% all the servos should be horizontal (level). they all go up at high stick and all down at low stick.
G
GaryGraham66 2 years ago
hallo Garry! is that ok when ol of my servos in SA looks down in low stick. not horizontal??
cypriotkikos 2 years ago
Hi they will only be horizontal at mid stick (50%) and then only with a linear pitch curve.
SA ?
GaryGraham66 2 years ago