HHO 7 CELL GENERATOR, ASSEMBLY
Uploader Comments (cavebandit)
All Comments (10)
-
Simple test HHO machine is effective or NOT. Park the car, start
engine to normal temperature, run to 1500 rpm and hold it there by
using tools or wedges. Turn ON your favorite HHO machine. Check the
RPM goes up to 1600 or more, it is GOOD. If RPM goes down or the same,
your HHO machine is ineffective, useless, and waste of time, effort
and money. Any seller will pass this test, buy their HHO machine.
(Forget the driving around wasting more gas, or read On Board Computer
Instant MPG).
-
as far as I can tell , you have no need for a neutral plate until you start the 2nd unit assembly. Try this configuration next + neg + nuet . , + neg + neut. so as you can see the neutral plate is only needed AFTER a set of three plates + - +
-
@cavebandit one way to stop over heating is to cycle the water
-
@cavebandit i have i'v tried using them they do nothing, better efficiency without them
negative plates do absolutely nothing but wast steal
batmanmob 8 months ago
@batmanmob
Please do some more research.
cavebandit 8 months ago
very god
luddjass 1 year ago
@luddjass
THANKS
cavebandit 1 year ago
What is a good plate design? And what is a good configuration? How much hho does this cell put out. I am wanting to start building some of these.
waterwart 2 years ago
If you really want to build an efficient setup go with a dry cell setup (lots of vids for these). Wet cells like this one will get hot and can never produce as much gas. As for this setup in the vid I have set it aside for better ideas.
cavebandit 2 years ago