Arduino Creeper Bot
Loading...
51,178
Loading...
Uploader Comments (howery2)
see all
All Comments (85)
-
EXCELLENT!
And this is Why, I'm studying computer science.
I liked software Engineering too But, idk..
-
Thats a Wicked project!
-
can you make a tutorial for this? i really want to make one but i am not very good with arduino or C++
-
if i had one of these i bet i could see lots of naked girls
-
Very cool idea, was a good that you swapped forward and reverse to the triggers on the controller for the final project. Love the addition of the camera too, although I'd have probably inverted the controls on the stick so that you press down to look up
-
coolest thing i have seen in rc yet
-
the download link on your blog isn't working :(
-
that is sick good job man
-
poor doggy ;(
-
That's really cool man!
Loading...
nice!!! where can i get the wireless cam that you have mounted on your project
glennlopez 11 months ago
@glennlopez Check out the project's blog, which has the parts and links. creeperbot.blogspot. Its a dot com
howery2 11 months ago
i was wondering if i could use arduino mega for it..or do i need duemilanove?
XXwikkiXX 1 year ago
@XXwikkiXX I'm sure the mega would work just as well.
howery2 1 year ago
Very cool. I am working on a similar project right now, far from finished. My question is, how did you make the speed variable? Is this in your code?
jaysonkarenjohnson 1 year ago
@jaysonkarenjohnson Basically, I am setting the "enable" pin for the drive motor on H-bridge motor controller with an analog pin. If I set the pin to 255, then the motor will be fully on. If I set it to 180, then it will go about half the speed. On the C++ side of things, I determine how far the right trigger is held down and determine the fraction of 255. Then I send that over to the arduino which sets the pin off that value.
howery2 1 year ago