LED brake and turn signals on a Sportster

A short video showing off my LED brake light and turn signals on my '06 1200 Sportster Custom. The tail light is a Kuryakyn Low Profile LED Brake Light (4970). The turn signals are Radiantz 48 LED 1.85" clusters. Also installed is a Harley auxiliary brake module (68286-04).

Category:

Autos & Vehicles

Tags:

• Sportster
• Radiantz
• Kuryakyn
• LED

[eskimojoe151]

with the turn signals being leds did u need a load equilazer? i want to go led with my sportster custom

[06bluesportster]

@eskimojoe151 I do not have a load equalizer installed. From what I've read and seen on my bike, you do not need the load equalizer if you just change 1 set of the turn signal lights. The front turn/run bulbs are stock filiment bulbs, I have the LEDs installed just in the rear. It did take 2 or 3 cycles of turning the blinkers on for the bike to adjust to them. It worked the same way when I tried them out on an '07 Dyna Streetbob.

[mypasswordishotdog]

will the lights work without the module?

[06bluesportster]

@mypasswordishotdog Yes, you could run the lights with out the module. The module only adds the extra brake lights.

[lanceoa]

did you get the Red LEDs for the turns or are you using clear with the Red caps?

[06bluesportster]

@lanceoa The LEDs are red, I already had the red lens from the HD aux brake light module.  What you are seeing are red LEDs shining through red lens.

[eskimojoe151]

@06bluesportster thanks for ur help and very nice sporty

[mypasswordishotdog]

could you go without the module?

[dabrownguy2]

those are so bright that it hurts to follow! but i like them

[lanceoa]

thanks brother

[06bluesportster]

@lanceoa The brake light was around $120 from ebay & the turns were $50 direct from Radiantz