Shuff's MMG Shuff's Mini Magazine Fed Garand

This is the Shuff's MMG in .308 fed by an M14 20 round magazine. The rifle shown is an HRA Garand modified to take the M14 Magazine. The rifle has an adjustable gas lock screw to get just enough gas through the system to make the rifle function without harming the gas system. The advantage to this is that you can use whatever .308 ammunition you like and just tone down the amount of gas operating the rifle. The stock on the rifle is just an old Boyd's I had laying around. This rifle also has a T37 reproduction flash hider. The barrel is just a tad over 16" long and has an 11 degree target crown. I can be reached at shuffsparkerizing.com

Category:

Sports

Tags:

• Shuff's
• Mini-G
• Garand
• Tanker
• parkerizing

[ctophu]

even though the magazine holds the bolt open, what happens when you take the magazine out to swap for a loaded one?

[ShuffsPrk]

@ctophu The same thing as the FAL's with no bolt hold open, the bolt goes home.

[ShuffsPrk]

Any commercial ammo is safe in my Mini-G's.

[Wireman134]

Rather have a M1A. I have a Arlington Ord. built T26 Tanker in 7.62mm NM bedded and unitized by me. Shoots 1MOA with M80 ball and my hand loads. Bought for $550 in 95' no way I'd pay for a Shuff''s for what he charges. Get a good used M1A and be done better. The Hell with chopping up the finest service rifle ever produced. Shuff's or any other butcher will never get any of my CMP M1's that's for sure.

[warftrat87]

i wouldnt cut up my M1

i would prob go with a M1a before getting a short garand... or a Tanker

but i checked out the web site and i like the Garand sniper model!

[phoneloan]

If you could modify that weapon so it would take a .30-06 magazine feeding system you would make alot of money because no one has done it. You couldn't produce enough to meet the demand!!!! Has alot of potential, just waiting for that modification.

[lilblitz]

why are you wearing serial killer gloves

[yarenyaw]

Is it safe to shoot any .308 ammo in it or is it like the .30-06 where you have to make sure it is either surplus M2 ball or otherwise safe to shoot so it doesn't mess the gun up?

[deadsalior]

so you cut up a garand to make a m1a

[nbenicewicz]

@ShuffsPrk Thanks.

I see that someone earlier asked about .30-06 BAR mag well conversions. If someone came out with a conversion that didn't require modifying the magazine and/or making a permanent change to the receiver I'd jump on it.