383 Stealth Ram with Ultraflo 4" exhaust idle/rev

Clip of my 383 HSR motor idling/revving with custom fabbed 4" single exhaust with 4" round ultraflo muffler

Category:

Autos & Vehicles

Tags:

• 383
• HSR
• Stealth
• Ram
• Ultraflo
• Dynomax
• Irocz
• Camaro

[chriscmc1985]

Is tht y pipe or dual that sounds awsome dude

[orr89rocz]

@chriscmc1985 In the description, single 4" exhaust so yes it a Y. Its 3" off the headers into a Y merge to single 4"

[ksilva808]

Hey Orr are you still on TGO im under karl's-92'-z28? Dam it sounds good, what is your engine specs? Im looking into a 383 HSR or Supr Ram build.

[orr89rocz]

@ksilva808 Yep still on there. Most of my specs are listed in my build thread there and in other vids of mine of this 383 motor..i think the dyno vid captures it, but it was a basic all forged 11 to 1 comp 383 with AFR 195's and custom grind using comp lobes. 230/245 .603/.613 109lsa. Ported HSR intake. Doing it all over again I would have gone with AFR 210's or Profiler 210's and made more power and pulled to 7K abit harder. Maybe a few more degs on the cam shaft

[preacherman198]

I have a 91 Z28, I'd like to no how this exhaust is routed

[orr89rocz]

@preacherman198 Longtubes into custom ypipe, header extensions for the ypipe go under the trans crossmember (hang pretty low) then down stock location in the driveshaft tunnel, into the muffler before the rear, over axle splitting into dual 3" outlets for dual tips out the bumper.

[orr89rocz]

That motor was awesome...I wish my new one would sound like this setup. Its getting a big cam too but the exhaust note was just so unique on this car...vids didnt do it justice

[86IROCZ86]

sounds beast! with that cam

[xxxXW4NT3DXxxx]

sounds stock.

[Weridprez]

I need help with my camaro guys. Not sure what year just know its a 3rd gen. and would like to have some repair advice. going to replace the thermostat to try and fix overheating problem. just check my channel out