How to Install AEM UEGO Wideband
Loading...
Loading...
8,653
Loading...
Link to this comment:
Share to:
Uploader Comments (TruckXLInc)
see all
All Comments (9)
-
And what if I wan't to datalog the AFR?
-
Can that o2 sensor be placed closer to the exhaust manifold or does it need to be further downstream?
-
be sure to check the manual for other models of WB. My LC1 specifies to NOT plug the WB02 in until other items are completed first.
-
what did u do with the wires off the stock o2 sensor ? any wire for lights on the gauge ?
Loading...
- 0:50
aem wideband rich idle lean when revdby turbpolo4,405 views
- 3:06
AEM Wideband Testby hoonyeah22,499 views
- 0:41
Running rich. Testing new widebandby prostreetcamaro3,821 views
- 1:14
Supra 1508 hp dyno pullby l3imboTuning47,688 views
- 0:07
Wideband works...I'm running rich.by acquacow3,263 views
- 4:25
AEM Tru-Boost Install - CntrlSwitch How-Toby srcsport4,490 views
- 0:37
Air/fuel ratio gauge installedby HughieW7,148 views
- 1:02
Auto Meter Air/Fuel Ratio Gauge (P.R.)by XxDarKBoY215,269 views
- 4:12
Haltech: Ignition Timing vs Air Fuel Ratioby haltechecu26,330 views
- 1:00
Mechanical vs electrical boost gauge comparison - NewSouth Performanceby NewSouthPerf52,183 views
- 0:59
Innovate MTX-L widebandby xxLiquidX3,340 views
- 6:29
AEM Analog Wideband Air/Fuel Gauge Install Part 1 of 2by wnos100shot31,329 views
- 0:17
800HP WRX MONSTER Part Three!!! (link to mods in description)by getalife04219,181 views
- 1:32
Erick's Racing Turbo Civic First day outby ericksracing29,051 views
- 0:37
0-100mph with air/fuel gaugeby adnedarn9,007 views
- 1:57
AFR at idle and acceleration (Aem wideband)by tunckan15,532 views
- 4:25
Turbosmart Dual Stage Boost Controller- Whats in the Box?by rallysportdirect6,379 views
- 2:14
AEM Analog UEGO Guage Overview - AEM Analog Air Fuel Ratio O2 Gauge 30-5130B 30-5130Wby AEMonly12,481 views
- 0:15
AEM UEGO Widebandby adamgm849,151 views
- 1:19
AEM wideband testby TechSalvager1,615 views
Yes it can in fact it would be better mounted in the downpipe.
TruckXLInc 5 months ago
Tyler's car is running with a Hondata S300 ECU, so he only installed the aem and closed the loop for the narrowband so he doesn't get the CEL.
TruckXLInc 8 months ago
If your vehicles ECU uses the O2 sensor for fuel control and you cannot recalibrate it for this different sensor signal, then you will need to retain the factory sensor. If you are running a factory ECU then you will need to continue to send it the factory narrow-band signal or it will throw a Check Engine Light (CEL). Additionally, on emission controlled vehicles in California you MUST retain the unmolested stock emission system for emissions legality.
TruckXLInc 8 months ago