Unboxing/Review- NZXT M59

not really unboxing but you get the point

Category:

Science & Technology

Tags:

• nzxt
• m59
• unboxing
• linus
• techtips
• pc
• build
• pcbuild
• computer
• case

[DynamicJDUB99]

True, i think im ordering the case anyway lol, if a dual rad wont fit ive got a single layin around somewhere, and i dont think rivets will pose too much of a threat, thanks much for the quick response!!

[TheSlayerIsBack]

@DynamicJDUB99 hahaha, well your wont regret it, i love it so far, im going to install my new PSU tomorrow and try out the cable management system and see if i can get it right, btw let me know when you get it and remove the hdd cage, ill want to see that, Good Luck

[DynamicJDUB99]

Is there room for a dual rad and i single set of fans in the top, and do you think you could remove the bottom HDD cage without alot of trouble

[TheSlayerIsBack]

@DynamicJDUB99 you can put a dual rad on the top of the case on the outside with a set of fans on the inside but the problem is that the clearance does vary from MB to MB since some sockets are placed lower or higher than others, for example with my old 775 MB with a CM hyper 212 plus i had like half a inch on the top so no regular fans will fit but with my am3 socket same cooler i have around 2 inches, as for the HDD cage unless you break of the rivets that cage aint moving

[DynamicJDUB99]

@TheSlayerIsBack thanks man, it might be a bit before i actually get it, but if you want imma put a vid up real soon of my current rig, its damn nice, you should check it out

[TheSlayerIsBack]

@DynamicJDUB99 sure ill check it out

[TheSlayerIsBack]

@KTCRITCH well ive only had problems with the molex from the "night light"

[KTCRITCH]

@TheSlayerIsBack In general. My first plug in 2 connectors backed out.

[TheSlayerIsBack]

@KTCRITCH well ill give you that one the molex are cheap and they break but only if you messing with them alot,

[KTCRITCH]

@TheSlayerIsBack They aren't very good quality at all. Especially when it comes to the molex and 3 pin adapters. the Molexs get pushed down and break very fast. The 3 pins seem fine. also when it came to the stock cable tie job. it looked terrible. Not sleeved or anything.