Pioneer Champion Pro Car Subwoofer (TSW2502)

Get yours!: http://www.sonicelectronix.com/item_16663_Pioneer+Premier+TS-W2502D2.html

For deep bass in smaller enclosures, consider the Pioneer Champion Pro car subwoofers. They feature a unique Air Suspension System that increases the overall output of the subwoofer. A large 85 oz. double stacked magnet increases the motor force, while the wide roll surround and rigid help keep the bass response clean and tight. For excellent bass in any vehicle, check out the Pioneer Champion Pro Subwoofers.

Main page:
http://www.sonicelectronix.com

Knowledge Base:
http://knowledge.sonicelectronix.com

Sonic Blog:
http://blog.sonicelectronix.com

Sonic Forums:
http://forums.sonicelectronix.com

Category:

Autos & Vehicles

Tags:

• Pioneer
• Champion Pro
• Car Subwoofer
• Bass
• Sonic Electronix
• Product Review

[Rjeezy786251]

Also I looked at the wiring guide on yall's website for tsw3002D4 and it only shows the diagrams for two of these on a monoblock amp to be wired @ 4-1 ohms...it said it was for the tsw3002D4 but I'm guessing it was actually showing the 2D2's since they can be wired 4-1 ohms and the 2D4's only 8-2...so if I wanted them wired @2ohms would I just wire it like its shown @1ohm on the diagram?sry not trying to confuse or complicate things just a little stumped and would like to figure out the correc

[SonicElectronixTV]

@Rjeezy786251 You would need to wire these Dual 4 ohm subs to 1 ohm on the amplifier in a paralell wiring configurations. Daisy chaining the postives to the positives and the negatives to the negatives. two of these subs need 2000 watts RMS and that is around what you will be getting out of the amplifier at 1 ohm.

[slimTXpimp]

If I was to run 6 of these on a bd 2500 cp would it be enough to power them good or would I need two amps?

[SonicElectronixTV]

@slimTXpimp Your amplifier will not be able to power 6 Ts-W2502D4 subs. You could easily power 4 with that amp but most definately not 6.

[SARDelta313]

What amp would you want for to power two 12" pioneers.

I'm looking for amps that will push mine as much as they can take.

[SonicElectronixTV]

@SARDelta313 To run two of these subwoofers, we would recommend the Hifonics Brutus BRZ2100.1D. This will give you 2100 Watts RMS at 1 ohm which is a perfect match.

[Rjeezy786251]

I have 2 tsw3002D4's and it's my understanding they can only be wired from 8-2 ohms, I ordered a planet audio BB2400.1 the rms rating for 2ohms is 1600 watts but I've seen pics of birth sheets for this amp tested around 12-1300 watts rms@ 2ohms would that be enough to push both of them pretty hard? I'll also be wiring with 0 gauge wire and a 3.5 farad absolute cap

[IamAtree000001]

Im deciding between one of these, and a kicker cvr, also 10 inch, whats your suggestion?

[SonicElectronixTV]

@mregg911 We have many options available on our website. Depending on what type of bass you are looking for will determine your box type. A ported box will give you a loud and deep bass but may sacrifice sound quality. A seal box will give you a tight and accurate bass but may not be as loud. The choice is yours!

[mregg911]

thanks for the reply. one more question tho lol. where can i buy 2 sub boxes to fit 2 of the pioneer ts-w3002d4 and what would be better a ported box or sealed? thanx