Storage Pin for Thule and Yakima Bike Racks - etrailer.com

http://www.etrailer.com/tv-demo_boone_cross_pin_BH83747.aspx

Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
This is a part that upgrades your Boone docking station to take Yakima and Thule racks, and virtually any other rack that uses a threaded fitting instead of a hitch pin. What this pin does is replace the original pin on the Boone docking station. Basically you just unclip these clips, pop off the one side and re-install with the new clips. This way you can install your threaded side out of your bicycle rack onto your pin. We'll replace the bottom one and show you how it works. We need to remove one of the c-clips and hold one edge of it, take a screwdriver and flip it up a bit. Once you get it started, get to the middle and put your screwdriver underneath it and slide it up with your finger so it doesn't fly off. Now re-assemble your dock block insert your new pin and make sure it's in correct orientation with the threads on your bicycle rack. You have to make sure because the threads are on the outside edge or else it won't fit on. Once you have it right, you can put your c-clip back on. We'll now install the bicycle rack with the threaded fitting. Just to give the point of view, we'll just point out that the threads are on this side of the shank. To show you how it works, look down there and see it's open and the pin goes through. One other thing about this is that one half you can use for your bicycle rack while the other half is open for any two inch accessories. There you have it for part # BH83747, the Boone dock cross pin for Thule and Yakima bicycle racks.

Category:

Autos & Vehicles

Tags:

• boone
• dock
• cargo
• carrier
• storage
• bike
• rack
• trailer
• hitch
• hidden
• reese
• draw
• tite
• curt
• valley
• towing
• etrailer.com