Gravograph IS400

IS400 engraving .015 characters in brass

Category:

Howto & Style

Tags:

• engraving
• IS400
• Gravograph

[douro20]

What is the line resolution on this? I'd imagine it's a few microns.

[brucelongstroth]

@douro20

The machine has a repeatability of .0005 inches.

[brucelongstroth]

The tools are 6.5 inches long and .171 in diameter a small industrial diamond is brazed in the tip and sharpened to a 110 degree angle. Call Holly at Machine Tools West for price and to order. 801 974 0638. The diamonds are also available in .125 diameter length is 1.5 or 4 inches long. A more common tip angle is 130 degrees included. I used 110 degrees in the video because of the small chsaracters (.015 Inches).

[Marcelmx3]

Do i hear this oke? is this tool about 30$? i was looking on ebay and came up one for 170$ :)

Please tell me how to get these diamond engraving cutters.... (ps is this spring loaded???)

Thanks !

[brucelongstroth]

The machine uses a top loading spindle that consists of a hollow tube supported with bearings. It has a thread in the top of the tube and the cutter slips into tube and is secured with a cutter head that screws into the threrads. The spindle is spring loaded and floats with spirng pressure on the material being engraved.

[goldi585]

is this spingle motor on or off is diamant rotary

[brucelongstroth]

The spindle is not rotating in this video because I wanted a more delicate engraved look. There is a toggle in the software to turn the spindle on or off.

[mikethenascarfan]

how much does it cost to engrave?

[darked777]

well, at least show us the fuckn result man !

[altar7]

Geez, if you can't even focus at the end on the final result, what are supposed to look at? serious

[goldi585]

can you put a have you make photo on is400

in metall