Lightbulb Vapourizer Hits & Review
Loading...
38,471
Loading...
Uploader Comments (glennkon)
Top Comments
-
Did anyone else check facebook at 1:20 ?
-
Thanks to the four dislikes the bar looks like a fresh joint
see all
All Comments (182)
-
Great vid but is there a smell from smoking it out of the lightbulb ?
-
@reservordog lmfao I was just about to say that xD
-
very efficient and informative video, awesome pipe! peace...
-
what about all the chemicals they use to produce the light bulb and the glass isn't clean?
-
Great vid but does the vapor smell at all and do you have to keep constantly lighting it or only a couple times
-
Does it smell as strong as when u smoke from a bong
-
But I like the I'm to too baked to do anything high
Loading...
I have a question, if the bulb is kinda frost it means its been made with argon(a chemical that when inhaled can seriously fuck up your lungs or kill you) , i learned that you can clear the bulb up by putting salt in it and kinda swishing it around does that really get rid of all the argon?
TimedSell 2 days ago
@TimedSell There is an article called "DIY Hollow Out A Light Bulb at TeamDroid". From step 8 of the article i quote: "This powder, is called kaolin and is pretty safe. You should still be careful and keep it away from your mouth and anything you might eat near." (accessed Feb. 2012) The argon is an inert gas within the bulb that will dissipate upon removing of the glass-encased filament and wont pose any further health risks. :)
Thanks for watching!
glennkon 4 hours ago
Please could you tell me if your vapouriser has an air inlet in the plastic cap? in order to draw fresh air in and thc rich out? thank u for a great vid
granhellosyan 1 week ago
@granhellosyan No problem. The plastic cap has a small air hole in it which i made by using a small drill bit (a hot pin/nail will work just fine). The hole should not be any larger than a few millimetres because there is then the chance of your vapour escaping. But as long as the vapour circulates out of the bulb and into the mouthpiece, there shouldn't be any issues :)
Thanks for watching!
glennkon 1 week ago
How do you get the nasty soap taste out
HaveSomeQuark 1 week ago
@HaveSomeQuark I used hot water and some elbow grease, but you could use an old brush and some pipe cleaners if things were being stubborn. I found that after a hot wash, a cool rinse can really help to remove any remaining soap flavour and/or debris.
Thanks for watching!
glennkon 1 week ago