2.3 duratec. ported head , fast road/rally cams,steel rods , forged pistons,std crank with keyways added, wet sump, jenvey t/b's ,pectel t2 management. built by Guy Turner of BURTON POWER for Andy Burton, tested by Steve Greenald of Race Engine Calibration. approx 250BHP 190FT/LBS Torque. not finished mapped as dyno manifold restrictive.
This is one bad ass Duratec engine. I would like to build one like this. How much did this build cost?
kentuckyboi777 1 year ago
That's how a four banger should sound.
Looptydude 1 year ago
what was the power like ,going by the gauge it was pulling hard?:)))
kevrs2 1 year ago
Loving th glowing purple exhaust lol!
SiMoNsKy22 2 years ago
Still in one piece at that point then.
kevmk2 2 years ago