SOMETHING NEW FOR HHO FUEL CELLS.

CONVERT DC INPUT VOLTAGE TO CONSTANT DC OUTPUT CURRENT WILL ALLOW CELL TO DRAW UP TO 32 AMPS,BUT ALLOW ONLY 12 AMP DRAW FROM CAR,AND REDUCES 12 VOLTS TO 3 TO 4 VOLTS AT CELL. TAKES VERY LITTLE KOH TO WORK 1/4 TSP.TO BE USED ON POS AND NEG SET UPS ONLY.

Category:

Science & Technology

Tags:

• HHO
• FUEL
• CELL
• DRY
• WET
• CELLS
• ZERO
• FOSSILE

[Hollywoods7]

powerstream sells it

[Hollywoods7]

YOU CAN GET IT FROM POWER STREAM,YOU NEED TO REDUCE THE PLATE VOLTAGE DOWN TO 2 VOLTS ,INTEAD OF 3 AND 4 VOLTS FROM FACTORY.THAT WOULD BE A MOD TO THE CONVERTER.

[waterwart]

ya it's great production...but is it getting hot?

[Hollywoods7]

@waterwart It is the 4 volts at the plate gap, which I already have a new converter from tggas which will have a lower and adj voltage for the gaps.

[Hollywoods7]

@Hollywoods7 what ever happen to tggas.

[Hollywoods7]

@waterwart Well you know if somethig gets hot there are ways to cool it.I did not get there yet.

[Javadavida]

I have found that if the cell design heats up the water too much you're wasting energy with a design problem. The goal is to make HHO gas, not heat.

[jocell202]

Nice, you gota check out my save money on fuel with one wire vid out.

[rclewis01]

@Hollywoods7 I don't know for sure, but I would think that water would resonate at different frequencies based on temperature, impurities, and water level. If you had a microprocessor circuit like an Arduino, you could send a pulse every few seconds and listen for the ringing effect. Seek the maximum ringback and use that frequency. Just an idea.

[n714x]

@Hollywoods7 What is the make and model number for the converter please

[HaveHandsOpen]

I use 2.2v to 2.4v 40A out, 12v at 7A to 8A in bin doing it for over 2 years now.

I use SIL40C-12SADJ-VJ DC/DC Converters & Regulators 10.2-13.8Vin 40A

[1forgotten]

Hi Great video , Where is converter brought from? ANY LEADS WOULD BE GREAT

THANKS

[budabob07]

10,000th view :)

[thesquater137]

Hey if I have a 32 plate pos neg setup will I run into any water vapor problems ?