1988 Mazda Rx7 NonTurbo Streetported redlining

1988 Mazda Rx7 streetported na redlining through the gears ( for those questioning my car's engine temp, my car is running at operating temp, its normally 1/4 of the way up fully warmed up..the car isn't redlining cold)

Racing Beat streetable header, straight pipe in place of cat, Borla 2.5" catback exhaust, K&N cone intake, ported throttlebody, removed secondary throttlebody plates, lightweight steel Racing Beat flywheel and Centerforce Dualfriction clutch, removed 5th/6th auxilary ports/sleeves/rods and actuators

Category:

Autos & Vehicles

Tags:

• Mazda
• Rx7
• Fc3s
• Rotary
• 13B
• Wankel

[wtfdidusay69]

my car is like 170 hp and 2600 l

[wtfdidusay69]

my car is like 170 hp and 2600 lbs

[wtfdidusay69]

my car is like 170 hp and 2600 lbs

[xxxH22VTECxxx]

I think my H22 Civic will beat your N/A RX7.

[Boogonomotry]

@xxxH22VTECxxx hahaha i think your h22 would lose :P

[wtfdidusay69]

my rx7 prolly pushing like 170 hp and weighs around 2600 lbs

[wtfdidusay69]

@xxxH22VTECxxx

my rx7 is like 170 hp and 2600 lbs

[90mustangracer]

Top speed shouldn't matter on your first car lol

[ScottiesVlog]

@CrownKing2011 Me and my brother got 150 out of his 1988 egi FC but then this is running just over 210 BHP

[CrownKing2011]

@rawrdinosaur212 LOL



[rawrdinosaur212]

@CrownKing2011 it all depends on how much fuel ya got. lol

[CrownKing2011]

Does anybody know the top speed for a 1988 mazda rx7? i have been trying too figure that out and nobody will fawkin tell me ahah ,I am asking cause that will be my first car =)

[TheSeaborneb79]

Thumbs up for Felix Wankel

[cowsys1]

@APUZER714

The S4 Canadian ones must be different since mine sits at just below half... unless my waterpump is dying.

[AyashiFX55]

@wtfdidusay69 im not a civic fan but a civic with swap engine from scrap yard (h22 ,500$) + a shitty civic for 1000$ , will have 200hp in a 2600lbs shell as well. Only very down side is : no rear disks , not RWD and looks gay ;)