T-DRILL HFT-2000

With the T-60 HFT you can produce twenty 1" outlets in less than ten minutes without moving the tube. The T-60 HFT can be used also for short tube lengths by furnishing the feed table with corresponding clamping systems. T-60 HFT is capable for producing collars NS1/4"-NS 2" (10-54mm) in run tubes from NS ½"-NS 4" (15-108mm). More details can be found in capability chart. T-Drill collars gives the most reliable tube joints being used with the most extreme applications. Use T-Drill - no leakages.

Category:

Science & Technology

Tags:

• copper Manifold
• heat exchanger
• solar panel
• outlet
• tee fitting
• T-Drill
• HFT-2000