Twister CP Gold rc Helicopter

Twister CP Gold test flight after repair. (medium breeze)

Category:

Autos & Vehicles

Tags:

• Twister
• cp
• gold
• rc
• helicopter
• hellicopter
• turbo
• taylor
• airplane

[itssssssme]

Just a quick note. Since this video I got the bottle to engage the 3D switch and it really improves vertical stability. No more bobbing up and down. I guess I must have got the throttle curve or pitch curves wrong so I am at wrong rpm for stable hover.

[hamblingpeter]

hey we just got one and we cant figure out why it wont stop spinning, the trim for the rudder doesnt work so could it possibly be that?

[itssssssme]

yes but you should be able to compensate with the sticks, or by adjusting the servo distance. if its second hand it could be the gyro is bust or the belt is on the wrong way, or even the rudder blades fitted the wrong way. this would make it snap into a spin.

[AfghanKnight007]

hi i have one of these, my first 6ch. but it really un stable , just drif to one side as it leaves the ground. even after treaming. is me not a good pilot or the heli has some problems. thanks

[itssssssme]

it could be jeclone already posted the answer. Try getting off the ground a bit higher to remove the effect of the rotor wash. Also start in a hall to eliminate any breeze and that way you will know if your settings are good or the conditions are bad. Good luck.

[Brokenwingking]

Why??????????????We dont need this Video on youtube

[CNCman200]

you can get them for around $200-$300 AUS 

[ChloeTheAwesome]

I got mine $200 the other day and tried it out like 5 mins ago, i managed to break it and when i was holding it it randomly turned on so i have a swollen and bruised chin.. :(

[MightyTighties]

Hey just wondering if this is a good helicopter, i am just about to buy one australian dollars cost $300 can anyone get it cheaper for me or can tell me this is good to buy.

Please give me an answer about how good this helicopter is.

[YasmiinTbh]

Yer that's a point. When you plug the battery to the helli yo need to leave it stood still until the gyro led is constant red. you will also hear the servos jump into position. Only then can you pick it p and move it to the take off position better still connect up in the area you are going to take off from. I think that this function is to orientate the gyro to its settling position.

[Chaotic6666]

cause i wasent aware tht when the remote was turned off it would test everything. when i did it it almost broke one of my blades but thank god it was carbon fiber lol

[Chaotic6666]

Dude i had the same problem right. so i read the intructions and it says do not turn on the Transmiter [remote], so i didnt [i can hear the gyro started making wierd sounds and such, then after it was finished, the blinking light on the gyro was constant Red. But BECAREFULL!! During the gyro stage thing[ where its testing its functions] It tests everything, and i mean The over drive switch for 3D Stunts. so what you should do is put sumthing very heavy on the landing gear stuff.