rapid coupler for different size shafts
Loading...
Loading...
322
views
Loading...
Uploader Comments (PovertyLabs)
Video Responses
This video is a response to Universal Mount Generator Solar Project Mount Steam Engine
Loading...
2:07
détériorations d'un clavetage, key coupling failure between shaft and hub.by jacquesmaurel3,961 views- 2:30
mother of all shaft coupling battlesby footprintawareness4,729 views
- 0:46
Facing A Marine Shaft Couplingby MaineCruising647 views
- 1:47
How to Remove a Drill Chuckby eReplacementParts142,752 views
- 0:12
Synthes 511.75 Quick Coupling for Drill Bitsby medfixsolutionsinc369 views
- 3:25
Propeller shaft coupling alignmentby pwcundiff5,827 views
- 4:25
SIMPLE STRUCTURINGby MinhNguyenRPES24,862 views
- 2:03
cnc lathe coupling rigid tappingby olifooks1,319 views
- 6:44
replace broken car side window (part 2 of 2)by PovertyLabs20,253 views
- 1:07
making a connection during Drilling an oil wellby riz12529,989 views
- 2:00
Dumore High Speed Automatic Drill Head, Ref.#18-251 (SOLD)by IndustrialSurplus802 views
- 0:40
9 Volt Battery Hack! You'll be Surprisedby kipkay7,189,922 views
- 0:37
Parts Sampleby Smartechcorp4,198 views
- 1:10
DIY - Missing Drill Chuck Key? - I Have a Solution!by FabKing115,580 views
- 1:56
What are Flexible Shaft Couplings?by DesignWorldVideo268 views
- 14:14
STEAM ENGINE TWO STROKE CONVERSION Weed Eater Steam Powerby GREENPOWERSCIENCE218,076 views
- 9:59
Top 10 Worst Foods - Nutrition By Natalieby psychetruth663,586 views
- 0:10
Quick Connector System Typ KI closes drill holes and connects them with a circulation systemby innomatec279 views
- 1:19
Sneaky Way to Drink a Beer!by kipkay4,847,068 views
- 3:56
Weekend Project: Rubber Band Powerby makemagazine239,514 views
That is tempered steel and may not weld very well (makes it brittle and will brake or crack )
I have seen Jacobs Chucks with Threads (most have threads) and so a long bolt and locking nut (cut the head off the bolt ) will give you what you want and possibly you could use different sizes 3/8 to 1/2 ?
What do you think?
GIZMOPRIME 1 year ago
@GIZMOPRIME I'm with you on the brittleness-the chucks are not too expensive, so to just try it out if a rapid coupler is important, might not be so bad. I did this video for Dan, I have the capability to produce a dedicated coupler with not so much fuss if I needed it.
I've not worked with the threaded chucks and suspect that the threaded end is solid - they would totally weld better, maybe be a little lengthier in use, getting good alignment might be a little more tricky.
PovertyLabs 1 year ago