Raku flames 12 17 09
Loading...
Loading...
191
views
Loading...
Link to this comment:
Share to:
Uploader Comments (MarksPottery)
see all
All Comments (3)
-
Raku firing is a lot of fun. Plus there is always the possibility of death looming around that makes it even more fun.
-
Hi Mark you should try backing off on the gas so that the flame stays in the kiln .I did this and trapped carbon in my glazes which made them go grey, also if the gas burns out side the kiln it wastes gas plus the temperature takes longer to rise as the unburned gas passing through the kiln doesn't add to the heat. I sounds a little obverse but in my experience in these situations less is definitely more ... just a thought
Loading...
- 1:55
raku firingby karenkstudio772 views
- 0:59
Raku in the rain 4 prized piece of the firingby MarksPottery3,911 views
- 5:20
Fabrication four raku, Manufacture oven raku,by potierdespleiades10,972 views
- 9:05
raku at brians for npa.movby NPAsoutheast183 views
- 5:46
kiln firings raku successes and failures001.MOVby stevebootonceramic987 views
- 9:02
SIMON LEACH HANDMADE POTTERY ~ Raku 2by sleachpots2,207 views
- 0:51
Tel Hai Pottery Symposiumby flatauer329 views
- 10:52
Firing Raku Pottery in the Microwave Oven: The Paragon Kiln Operation Seriesby ArnoldHoward14,609 views
- 7:54
Raku Firingby charms41996 views
- 5:22
CSJH The Grace [Tenjochiki] - A Little Bit Of Goodby sukilovesdbsk70,024 views
- 1:38
Raku 5 - Finished Piecesby mkendo20,887 views
- 7:51
enclosed pot with a wirecut top part b.movby stevebootonceramic334 views
- 3:10
SIMON LEACH - how to make a simple RAKU kilnby sleachpots104,758 views
- 2:54
Gas kiln yellow flameby MarksPottery1,118 views
- 10:00
RAKU FIRING - ASHES TO ASHES RAKU FIRING AND CRICKETby SeaSharkGull382 views
- 0:40
Frimkess kiln firing 29by PotterySchoolDotCom7 views
- 4:24
Rakuby tewtle293 views
- 1:07
Gas fired kiln openingby MarksPottery419 views
- 1:03
Black and green SSCby MarksPottery538 views
Steve I was finding how to get reduction in this kiln. I later turned down the gas and saw the temperature rise after that.. I know I got reduction by the way the glaze turned out, by how much copper showed, now need to do it with less flame. I will do a run with the same glaze and no baffle plate on top at all and see how it does with that
I appreciate your feedback and comments as always.
Mark
MarksPottery 2 years ago