Arduino Wireless POV (Part 1 of 2)

Here my Making of the Arduino Wireless POV. Starting from an old floppy disk enclosure and a old CD-ROM box. Im using a compatible arduino board. Featuring automatic calibration with a IR sensor to detect loop start and adjust letter width (timing). Very simple to do, cheap and lot of fun!

Im working on the Wireless interface that use a tiny 433Mhz CEBEK module (emiter and receiver) for sending phrases over USB and sending it to the on board receiver to draw the text on the POV.

To be continued...

See more at: http://www.bricogeek.com

Category:

Howto & Style

Tags:

• arduino
• pov
• wireless
• embedded
• led
• barebone
• diy
• cebek
• 433
• mhz

[curlyfry562]

How many times have parts come flying off?

[pekepowah]

@curlyfry562 one (the battery) and hit my face two times. Then I glued it to the chasis :)

[MrHellsguardian00]

which motor are u using? what is its speed? i made one but the pcb has vibrations because of which the motor is taking a lot of load..

[MrNeoFromMatrix]

can you upload the code and cirriut plan ?

thankx

[superant10000]

@pekepowah Hahaha it hit you in the face >_<

I creased up when I read that xD

[shebotnov]

@pekepowah >DDD

[dumle29]

@graymalkin1234 yes it is. it sends the data to be displayed wirelessly... lol

[stickydone]

¿Dónde puedo descargar el fot código de este proyecto?

where can i download the code?

[94thts]

Was it hard to balance properly?

[graymalkin1234]

That is not wireless lol

[TrickyNekro]

@TrickyNekro

Basically my bad... it's available on here yutube ;-D

Chus Barrera - System

watch?v=F_34l8Id2j0

All hands up to techno :-D

like this comment... ;-P