Sherline CNC Gear Cutting Part4
Loading...
Loading...
37,614
Loading...
Uploader Comments (Hobbynut)
see all
All Comments (11)
-
buena explicación
-
I think he meant the actual adjustment of the jaws to centre the mandrel.
-
Where'd you get that particular thre jaw chuck for a sherline lathe?
-
Yes you are correct I am only talking about standard involute gears here so the other calculation will not apply. Thanks for the comment I hope that the videos help in some way for you.
Loading...
7:49
Sherline CNC Gear Cutting Part5by Hobbynut124,141 views- 10:33
Home made Gear cutting Hobs part4by Hobbynut250,364 views
- 2:34
Hobbing (Gear cutting) on a Mini-Mill with EMC2by blyndpew36,554 views
- 1:29
Sherline CNC Gear Cuttingby zircotube54,565 views
- 2:10
Gear Cutting, Brunkerville Engineering, Gear Design & Transmission Failure Analysis.by rolvon79,876 views
- 0:26
Sherline millby tgreening29,457 views
- 3:22
Sherline Mill CNC 4 axis machiningby rdgtm72,346 views
- 0:28
CNC Turning on the Sherline Millby microsteppingcnc80,718 views
- 9:55
My Sherline Vid 1by Setharoo212,682 views
- 2:28
CNC cutting of a 29 tooth Helical gear using EMC2by davethearchivist530,365 views
- 6:50
Making Involute Gear Cuttersby myfordboy64,024 views
- 0:48
First Sherline CNC Milled Pattern...by formwalt36,250 views
- 4:14
Sherline mill CNC machining radius Millingby rdgtm28,155 views
- 0:20
cnc, worm cutting, nacinanie slimakaby bolero2222,633 views
- 8:09
Showing gear cutting using the Mumford/Sherline CNC indexerby TTompion19,073 views
- 3:19
Gear Cutting, Brunkerville Engineering, Gear Design & Transmission Failure Analysis.by rolvon83,186 views
- 1:08
Making Gearsby precisionae100,958 views
- 4:42
The LATHEby OldSchoolMachineShop81,546 views
- 0:25
Hob measurement in the workshopby feanorou162,199 views
- 3:17
how to make a hobbing with an MT gear hobber driven toolby mtmarchetti103,477 views
This is good stuff, it is people like you that keep people smart, do you know how long it would take to research all of the stuff you have shown? forever, and to get it right too.
ptwolfe99 2 years ago 6
Thanks, It took me quite a while to figure this out but as always I am willing to share what I know with all that want to listen.
Hobbynut 2 years ago
Can you share the trick for centering in a four jaw [independent] chuck, that is if you haven't already?
togaida 2 years ago
I showed the set-up for doing this in the video so I am not sure what you are asking.
Hobbynut 2 years ago
YoU have got to be the only person that I have ever seen take a chuck off a lathe in order to preserve accuracy.
Abovegroundminer 3 years ago 2
With the sherline equipment this is a very accurate way to move the part from the lathe to the mill. It seems that sherline has done a very good job in making there equipment and chucks.
Hobbynut 3 years ago