JAWA 350 RT TS CAFE RACER SMALL END BEARING ROLLER TOOL FROM:

jawa r.t t.s. 350 caferacer small end lose roller tool Yezdi Cezet: In association with www.townsreunited.com

Category:

Autos & Vehicles

Tags:

• motorbikes
• jawa cz cafe racer
• mechanical
• tips
• jawa
• r.t
• t.s.
• 350
• caferacer
• small
• end
• lose
• roller
• tool
• Yezdi
• Cezet:
• In
• association
• with
• www.townsreunited.com

[zip343]

Wow...I'm learning more and more...Tool maker?...I had no idea...sitting here slack jawed...I'm so impressed...Thank you Terence...Thank you too David for the vid...your brother is a genius...

[miniporter2000]

@zip343 Your welcome zip343

[XxX123steph123XxX]

Well, Done Grandad Very Cool

[jawaczman]

well done trrence been there done that great tool

[terence20001]

@DAVIE1488 Hi  Thank's pleased you like the vid . Terry

[DAVIE1488]

good stuff !

[terence20001]

Hi , Yes i agree the caged rollers are easy to fit , and they roll better rather than the loose may scuff a little , I use this tool when i know the small end's are o.k. and intend to put them back . Thank's for your comment . Terry

[superbran2008]

i have a jawa babetta and there the same roller type bearing but i replaced it with cage roller bearings there a lot more efishiant and do not mesh like the ones loose without the cage i foud out that i do not get piston slap?? naw but before it did and thanks for the info on the special tool it took me ages last tyme i built one

[terence20001]

@enfielddnepr . Yes you can make this tool from old piston pin , Need surface grinding though for more clearence . Thank's for your comment , I'll try to find out those measurment's for you . Cheer's Terry

[enfielddnepr]

make a bush from an old piston pin?

another question,\ i also have this type and engine, runs good but some have factory mistakes in the cylinders. ports are not at the same spot as the canals, so partly blocking one-other..

Does anyone have the data from factory about the distances and measurements of the ports in the cylinders??

[terence20001]

@stepanprasiq , Appriciate what you say , Cheer's , Terry

[stepanprasiq]

No to si dělá srandu ne, děda anglickej? On tam to jehlový ložisko šoupl jen prstem?? To nemyslí vážne.............