Clip-ons for a GSX-R

I replaced my old bent handle bars.

Category:

Autos & Vehicles

Tags:

• Motorcycles
• Suzuki
• GSX-R600
• gixxer
• gsxr
• Vortex
• clip-ons
• handlebar install

[GunForAll1]

What exactly is the plus side to replacing the stock bars with the new clip ons, i mean the original ones have a tilt to them and the new ones do not have a tilt. They are straight. Does this make a difference, yes i know they are adjustable too, but if you slightly lower the stock ones you can adjust them too. I want to know if there is a benift to getting rid of that tilt.

[mrgeeunit]

@GunForAll1 They do have a tilt to them. my reason for new clips ons was to replace my bent and smashed ones. I had another drop which bent a bar. 12 bucks later and i replaced it with a new bar.

[GunForAll1]

also you have Vortex too, i see that they make a 0 degree tilt and a 7 degree tilt. I just found that out today after my 1st comment.  :)

[GunForAll1]

also i see a lot of motorcross bars strait out and they can turn these bikes to hell and back with ease too. So i am going with the further out, and strait bars and hope i get what i plan on as far as making the bike more familiar to me like the old days BMX and Motorcross. Let me know your thoughts. Thanks.

[GunForAll1]

I see a lot of racers with the 0 degree bars, i look at them and think that would actually give me better physical referance as to where the front tire is pointing when in a turn. You knwo like the old days when all you had was a bmx bike. The strait bars i have on my little MINI bike are strait and almost strait out, and i can lean that baby and control it like no tomorrow. I got the vortex right now online, they are the only ones i have seen with the 0 angle.