Avalanche Beacon Practice 3, Multiple Burial
Uploader Comments (GavinHope)
All Comments (8)
-
Good luck - make sure you don't switch to multiple burial mode before locating the first buried victim though. If you're in multiple burial mode for the initial search you're only making things harder for yourself. Only switch over to multiple burial mode after you've located the first beacon and need to eliminate that signal from your subsequent search.
-
FYI - that DTS tracker has a function that narrows the search angle for multiple burials.
Press the button above and to the left of the red search button and it narrows the search down to a 75 degree angle - makes it a lot easier to eliminate the first signal found and find the second buried beacon. Give it a go next time you practice!
-
Thank you!!!!!
-
pieps DSP would of done better, and even more the S1 for multiples.
-
Very good job mate!
Thanx for the vid,
Very helpful, I shall shown all the 3 vids to my skymates.
Cheers
What is the tracker tracking ? Please tell me
smoothymaker 2 months ago
@smoothymaker Hey - it's just another BCA Tracker... the other beacon is wrapped up inside a plastic bag. Cheers, Gavin
GavinHope 2 months ago
Basically use the full search range to find the first signal - then hit the multiple burial button to make it easier to focus on finding the next signal without getting interference from the signal you've already found.
Ramanjuna 3 years ago
Cheers! Haven't had a chance to try the other mode... I wanted to try them both, so started with this :)
GavinHope 3 years ago