Proof Of Concept Ver2 6N3 005
Loading...
2,667
Loading...
Uploader Comments (vipond50)
see all
All Comments (18)
-
TRIED TO CALL YOU BACK 985-276-3445
-
@GULFCOASTCLEANENERGY NEW ORLEANS I HAVE THE SET OF PLANS " 5 X 5 GAS SPLITTER " PDF FILE
-
WHERE CAN WE FIND THE MATERIALS TO BUILD CELL ?
-
The 5X5 Ver2 was at 2.5 L/m if I recall when the video was taken. The 8X8 produces 6 L/m at it design spec. Please keep in mind the the gas are separated (2:1 ratio). Volumes were taken from both sides of the cell to look at Ratios and possible losses due to the electrolysis process and design.
Bill
Loading...
I'll attempt again tomorrow Your on the east coast correct?
What a good time for you?
Bill
vipond50 1 year ago
WHERE CAN I FIND 100% Rip stop Nylon (Uncoated type) ?
GULFCOASTCLEANENERGY 1 year ago
@GULFCOASTCLEANENERGY
vipond50 1 year ago
@GULFCOASTCLEANENERGY Seattle Fabrics dot com Look at the 1.9 oz material
vipond50 1 year ago
@GULFCOASTCLEANENERGY Where are U located?
I also asked if u had the planset... Do U ?
vipond50 1 year ago
HOW MANY LITERS PER MINUTE ?
GULFCOASTCLEANENERGY 1 year ago
@GULFCOASTCLEANENERGY
The same places that you would source the materials for the standard Tero common duct searies cell. The only addition is the separater material membrane which is 100% Rip stop Nylon (Uncoated type).That the point of this design, it changes to a Biducted cell flow sheet.
Do you have the plans set????
Bill
vipond50 1 year ago