Lister 6/1

1st test run with ST5 head. The ST pulley is undersized at 10 inch and hence the engine is running at about 600rpm for 50Hz output. My engine setup is still short of a fuel tank, exhaust, intake and a radiator.
This Dursley Lister serial 8327616 is well behaved and running smoothly on the frame without any anchoring to the floor.

Category:

Science & Technology

Tags:

• Lister
• CS
• 6/1

[decoysk]

HELLO ! WHERE COULD I PURCHASE ONE ! THANKS

[swleesr]

@decoysk

there are quite a few units left. go to my listerenginegallery to see it. shipping cost from the far east is going to be the deal breaker though.

[swleesr]

Hi Leonscorpio, thanks for your comment. I play with many old engines but i have to say there is something magical in the Dursley CS. Everything about it is simple and yet it works.

[mytickets]

I would like to get 20 or 30

Thats fine

Thanks Jeff

Shipping would go to LA port

west coast

East coast would be OK .But ould need to truck to west

[swleesr]

Hi Jeff,

drop me an email

[mytickets]

Hi can you find me a good 6/1 and have it shiped to Phoenix AZ

Thanks Jeff

[swleesr]

Hi Jeff,

there are quite a handful to choose from but the freight cost would be disproportionately expensive. unless you fill up a container load with 10 or 20 engine.

but i will explore LCL cargo to your world. which port of discharge shall it be?

[leonscorpio19]

This is such a beautiful engine... everything from the hand crank starting to the put put sound it puts out.. i've been looking for one for a while now in the U.S... no one wants to sell them!!!

[steamwally]

I'm sure the editors would be very gratefull for another story to publish, their allways looking for good quality articles such as your article.

Good luck,

Phill.