HHO Generator Test #4

Tests 1, 2, and 3 were not filmed but here is what happened:

Test 1: plate design of +-+-+- and baking soda electrolyte ; worked fine but I found out that was very uneffecient, produced Carbon Monoxide, made brown soup, and was basically a water heater

Test 2: plate design of +nnnnn- and lye electrolyte: Basically no results, I guess my power source does not have a definate enough voltage to work that that many neutral plates and low voltage

Test 3: plate design of -n++n- and lye electrolyte; Same as Test 2 but with a little less than better results. I soon found that my small batteries couldnt take the load

For this test I have the same plate design as before but with new Deep-Cell Marine battery (12 volts) and used that. I re-sealed the containers and set it up.

The plate design is from SpeedStick3D

I measured and the barb is 1/4" wide so I guess that is its rating...

Please comment and subscribe!

Category:

Howto & Style

Tags:

• HHO
• Hydrogen
• Oxygen
• Generator
• torch
• metal
• cell
• plates
• neutral
• cut
• braze
• weld
• welding
• burning
• explosion
• bubbler
• safety
• chamber
• tank
• gas
• blow
• up
• tube
• glue
• oxyhydrogen
• power
• heat
• fire
• energy

[streetphase]

thats pretty good, what did you use as plates? blank switch plates?