Over Unity Free energy Motor Generator_1
Loading...
6,432
Loading...
Uploader Comments (toranarod)
see all
All Comments (27)
-
To show over-unity you need to show POWER in and POWER out. Power is Volts x Amps. Then tell everyone how you set you equipment up so we can reproduce it. If it is real we should all be able to do it. I hope it's real. I'd love to be able to power my car and house for free.
-
PDF up on YOUR open source uni next week
-
@mikepowers420 With no apparent heat. If timing is correct. Its this phenomena that has got me hooked because it seem to throw the standard equations’ out the window. So with others building it I stand to be corrected.
I just want to know more so I am looking forward to hearing others with there input
Cheers
Loading...
Note for reference: A relay was used to conduct this experiment and provided a working prototype for a short period of time: however, the relay contacts eventually burnt out. Future switching will be done by a solid state circuitry which will be documented in future references of this research.
toranarod 1 year ago
was reached to bring the capacitor up to a 48 volt charge before it was discharged back to the batteries’ 24 volt potential. By using a counting sequence instead of time to calculate the charge potential of the capacitor we were able to maintain a 48 volt charge peak irrespective of the motor’s RPM.
toranarod 1 year ago
Note: Resistive capacitive time constants need to be considered so the capacitor can be discharged to the correct potential of the battery. This duration time is also calculated by the micro processor.
It is also important to note that the micro processor counts how many times it has triggered a drive pulse and uses the amount of ignition pulses to determine how long to charge the capacitor before returning the charge back to the battery.
In the test shown here a pulse count of 250
toranarod 1 year ago
The capacitor is allowed to charge to twice the battery voltage potential, i.e. 24 x 2 = 48 volts. At that time the processor determines the right moment when the circuit is no longer switching to return to activate the relay and switch the voltage stored by the capacitor back to the battery source, returning all energy back to the system.
toranarod 1 year ago
For the intent of keeping this as simple to understand as possible, I have used an electromechanical device, i.e. a DPDT (a double pole double throw mechanical relay) to demonstrate how the capacitor C2 is switched mechanically in and out of the battery charging circuit.
In normally closed position, the relay connects the capacitor to the drive coils L1, L2 and is allowed to charge through the 2 rectifying diodes, collecting the high voltage EMF off the collapsing magnetic field.
toranarod 1 year ago
you are so totally correct.
only power can show over unity.
cheers
toranarod 1 year ago