Martel Autos Push Bumper Install

let Martel Autos Install your next push-bumper

Category:

Autos & Vehicles

Tags:

• Martel Autos
• p71
• crown vic

[Trainmasterryan]

do you know which setina model would fit a 97" crown victoria. i contacted them and still havent heard back from them

[djhershey91]

@Trainmasterryan Um not sure about setina i have a setine book and fromt he picture in the book looks like the PB400 will fit on 03 and up....i will find out more and let u know

[Trainmasterryan]

@djhershey91 i found which one i need. its the PB300.

[djhershey91]

@Trainmasterryan ok ok

[zangazoo2007]

I have the Setina PB400 (aluminum version) for a 2000 CVPI and I can tell you that the instructions do not say you may have to drill. The holes are there, but on the passenger it is an oval, and the drivers it is round. No room for any adjustments. The fascia is also held on by plastic vertical brackets that are not adjustable from L-R. Mine still sits 1" off center towards the right. I've yet to figure out a work around. It's a pisser let me tell you !

[Trainmasterryan]

where do i make the cuts to mount the brackets. i got an email for the PB100 and they said i need to cut two slits to mount it. but they didnt say anything bout removing the front fascia.

[evxdaddy]

@Trainmasterryan Dang Thanks anyway :(

[Trainmasterryan]

@evxdaddy i dont think you can put one on that old of a car.

[djhershey91]

@Trainmasterryan um think 50.00....

[Trainmasterryan]

@djhershey91 i meant for installation. the bumper i want is a setina PB300