AFAccord's 2000 EX Coupe - 2-step Launch control

Playing around with launch control in eCtune. This launch was way too high, and would have been a faster run if I hadn't spun through 1st gear, but I only did this for the entertainment factor.

Car is converted to OBD1, using a P61 ECU running eCtune. At the time this video was taken, the car was fully street tuned. I believe mods at the time were just intake, ebay header, H23 trans, and tuning.

Category:

Autos & Vehicles

Tags:

• accord
• race
• 0-60
• launch

[afaccord]

lol, you guys know I'm using a combo fuel/ignition cut, right? The tach does that cause it's not receiving a decent signal when I hit the 2-step.  If I hit it a little lower, it tends to bounce around the correct rpm.

[afaccord]

Was recently converted to OBD1 with a chipped P61 ECU, and street tuned with eCtune. The car has an aftermarket intake, and an M2S4 transmission from a 96 Prelude, but otherwise, it's a stock F23. I don't normally rev that high. I just wanted to make a point to get over 60mph in second gear, which can't be achieved with this transmission and the stock rev limit.

[jsaulgodoy]

is this the f23a1? or the ULEV cyclinder head, cuz the ULEV heads have very poor flowing compared to the normal head...

[andthenwhat23]

Does tuning make that much of a difference?? I have a CAI and Headers on this exact same car???

[bobfull]

Wow its fast check mine;)

[cardie1234]

dont think the tach was happy with the change in signal so quickly lol

[echohead88]

haha that was the funniest fuckin comment anyone has put on here. thanks ka24240!

[ka24240]

hahhahaha the tack f**kin went derrrrrrr

[epicvelocity]

ROFL @ the tach. Hahaha, one of the funniest things I have ever seen on YT. =P

[signfid376]

damn! thats fast. what did u do to raise the fuel cutoff?