Altium Designer PCB Layout Part 4
Loading...
Loading...
7,213
Loading...
Uploaded by antoker on Feb 13, 2010
A speed up (x8) of actual PCB layout process done in Altium Designer Summer 09. This video has been recorded just to show a complete process of a PCB design and to demonstrate how much work an egineer does. More videos will follow as soon as i have more spare time. This is a audio board has quad audio inputs, dual audio outputs, serial connection to a pc by the means of usb, infra-red reciever, and a VFD display.
14:17
Altium Designer - DDR2 routing and layoutby matarofe6,174 views- 4:42
Altium Designer PCB Layout Part 6by antoker11,588 views
- 2:29
SolidWorks 2012 vs Altium Designer 10 for 3D-PCB Designby shadowwares3,494 views
- 8:06
Altium Designer PCB Layout Part 3by antoker6,149 views
- 0:27
Eagle3D - Demonstrationby mflemos8713,146 views
- 9:54
PCB Tutorial - Routing (Part 1)by GabeCohn19,835 views
- 8:35
PCB Tutorial - Schematics (Part 2)by GabeCohn11,102 views
- 6:58
Altium Designer PCB Layout Part 1by antoker38,591 views
- 8:21
Altium Designer Tutorial: Navigating designsby elektroniskorg4,868 views
- 3:20
Gerando fotolito negativo no Altium Designerby procontrolengenharia1,580 views
- 5:27
Rapid PCB Developmentby RapidPCB94,713 views
- 10:05
PCB Tutorial - Schematics (Part 1)by GabeCohn21,913 views
- 2:04
hirox 3D digital microscopy: 3D inspection of PCB - SMT - Semiconductorby hiroxEU4,632 views
- 9:31
PCB Tutorial - New PCB Layoutby GabeCohn8,275 views
- 7:36
AD10 Layoutby antoker2,325 views
- 2:20
PCB Design Layout Process Part 1by Nexlogic26,015 views
- 17:46
Altium Designer Tutorial: Start Schematic & PCB Layoutby matarofe5,975 views
- 0:28
3D Single Layer Modeby AltiumOfficial7,698 views
- 7:42
Altium Designer Tutorial - Printingby matarofe3,580 views
Thanks for posting this video! Looks like manual layout involves quite a bit of work for such a large board! The largest I've done is only about 25 nets or so and I thought that was hard!! This is awesome! Quick question: are you using a grid snap when placing traces or is it just freehand?
coolboarder44 1 year ago 2
@coolboarder44 well, most of pcb layouts are done manually, unless it is a 16 layer motherboard with tons of bga's, then fanout is done automatically because of high pin count. Typically I'm setting my grid snap to 10-15 mils when routing "normal" traces and altering between 1-10mils for component placement or when routing high-speed differential pairs.
antoker 1 year ago
awesome timelapse.and awesome track.Where can I get these kind of songs?
SkyDiver17 1 year ago
@SkyDiver17 the genre is called DnB (other songs are more breakbeat-ish). This particular artist is called Triad. (prostopleer site should've them)
antoker 1 year ago