Kenne Bell 2.1l GT first dyno pull

2002 GT with long tubes, bassani cat back, Kenne Bell 2.1l at 9psi with the water to air intercooler. This run stopped just short of 5500rpms. The car put down 402hp and 366tq to the rollers. I'm using the factory ford air inlet and MAF which really limits my numbers, also the tune that came with it was more than safe dipping below a 10:1 air fuel ratio. Given some simple changes the numbers may turn out better, yet I don't want to push it much more as I would be on borrowed time with the factory internals

Category:

Entertainment

Tags:

• kenne
• bell
• 400hp
• mustang
• gt
• 2002
• supercharged
• twin
• screw
• ford

[Sk8FalIen]

@sinister99gt please post a vid of ur build when ur done it sounds pretty sweet.

[sinister99gt]

i have had my kenne bell on for a year and a half on a stock block, 99 gt . i put it on when the car had 105 ,000 miles on it and it still runs great. it made 408 rwhp with the kenne bell chip, 408 is the most it will make with the stock mass air meter so you are about maxed out . i have been down the track a bunch of times with no trouble.i am building a badass 2v right now, should be done by the end of the month . it will have everything you can think of and then some. costing me fortune.

[Sk8FalIen]

nice car, what does it run in the 1 4 mile?