you could have drilled 8 holes in one piece and rather than threading the Plexi, you could have used stainless nuts on either side to hold them in place. much less time consuming.
These are two cell in one,and the top of the bolts is were the electric wire is going to be attach with a strap so the electricity pass througth the bolt into the wire.
hello josejir..I was wondering would it be alright to make some resin and mold it arond the ends of the stainless steel.instead of cutting through it..thank you
you could have drilled 8 holes in one piece and rather than threading the Plexi, you could have used stainless nuts on either side to hold them in place. much less time consuming.
eyezbback 3 years ago
These are two cell in one,and the top of the bolts is were the electric wire is going to be attach with a strap so the electricity pass througth the bolt into the wire.
josejir 3 years ago
hello josejir..I was wondering would it be alright to make some resin and mold it arond the ends of the stainless steel.instead of cutting through it..thank you
blueshadow1996 3 years ago
If The resing get hard,and if the cell dont twist or shake is good.
josejir 3 years ago