HHO power supply #3

This is a 1 transistor design using a ringing choke it requires some coil winding but is fun to play with.
R1 180 Ohm 1W Resistor
R2 47 Ohm 1/4W Resistor
R3 2.2 Ohm 1W Resistor (only needed once)
C2 100uF 16V Electrolytic Capacitor
C1 100nF Ceramic Disc Capacitor
Q1 TIP 3055 or 2N3055 or equivalent
L1 See "Notes" T1 See "Notes"
MISC1 Wire, Case, Board, Heat sink For Q1, heat shrink,
Ferrite AM antenna rod for coil ( I like the bar type rod because you can make bigger cores by stacking.) MORE POWER. L1 and T1 are wound on the ferrite bar or what ever core you like (iron or steel works too) Lay your primary first 24 turns of 18 or 20ga. insulated magnet wire. You can interlay L1 with 12 turns at the same time and mark. The secondary is 400 turns of 26 or 30ga. Of corse if you would like higher voltage do more turns.
R3 is used only once to test the circuit and can be taken out after you see it is working thhough I would put a fuse in at that point a 10amp will work.

Category:

Science & Technology

Tags:

• HHO
• Fuel
• Cell
• Energy

[1miltond]

Hi is L1 A choke? I honly see 1 coil If is not were you connect The secondary ?

[crazzieg]

Look to the right of the page and click More Info...

[b130dell]

hi, why dont you show the actual circuit that u have made.

[crazzieg]

look at the next few I get past that

[intusut]

Dear Sir,Where is HHO power supply #1 ,2,How much turns and what awg foe L1,also how much turns of pri.and sec. of tranformer and awg..Do I use ferrite tansformer instade,thanks sevi.

[crazzieg]

All th information is in the drop down (MORE) to the right of the movie.

[TRONhack3r]

Great job... Yeah just don't touch terminals at t1 / ground and you should be fine t1 is a set-up transformer the rest of the circuit is a lc pulse.. I luv engineering ^_^

[HeathsWorkShop]

Hey Thanks for the video. But can someone please dumb this down for me . I have no knowledge of converter. I'm want to use this in welding . any help will help thank you.

[KyleCarrington]

Hey thanks for this. I've never done high voltage electrolysis, I've always done brute force 13.8VDC, but this circuit is very useful for anything,... if... I understand it to be what i think it is... Is this basically a 12VDC - ??VAC Modified Sine Wave Invertor? Depending on your windings? Thanks. Will follow your stuff. Right on. Do you think you get further with High Voltage HHO production than DC? Cheers

[poprock4me]

This circuits is working , i made it

[adicontakt]

@rcjetpilot707 read the description of the video

[rcjetpilot707]

Please give the valuse for the componets.

[0903390901]

bla bla bla ... Where are the real experiment?

[prototype9000]

2n3055HV will handle like 63 amps at 400 volts

[kaitlyn61]

Find winding a transformer intesting could you show us how you would wind a transformer in a video keep up the good work find all your video's great