Vertical HHO cell 6-10-08

I am using 316L stainless in this setup (only way to go!) Don't have to change the liquid just add more. Uses about half the container in 200-300 miles.

These are the units I am selling and installing locally. I apologize to those of you that want me to sell these on the web. I can't keep up with the local orders right now but hopefully they will be on soon.

Thanks for all the great comments! HHO YouTubers are great!

Category:

Howto & Style

Tags:

• hho
• cell
• hydrogen
• 316l
• stainless

[pharbach]

Where did you get the clear container shown in this video...I have been looking around but have not been able to find these.....HELP!!

[KyHydro]

Walmart

[delvis11]

what do you use the keep your bolts on the side from leaking? can you explain what gule, washers, seals used?

thanks for your reply

[KyHydro]

GOOP marine or LocTite marine are the only ones I have found. They work great. Boat store might have something better. I glue the crap out of everything, don't want leaks. Washers were a PITA to deal with.

[boracay12]

kyhydro, how did you hook up to your diesel engine ? i made a cell and it looks to be putting out a lot of gas . but after running a full tank of fuel ,i see no increase in mileage , i ran the fuel cell line in between the air filter and the turbo

[KyHydro]

I hooked mine up between the air filter and turbo also. Make sure you are pulling at least 15 amps. I didn't get any good results until I hit that amperage.

[n01imitz]

I come down to KY every once in a while, is it possible I could buy one of these cells from you?

[JeffNhardy11]

cool....

[dragon64leo]

Hey KyHydro!

The HHO cell you have has to be about the best one I have seen so far(better than a Joe Cell), and I am still in research mode right now. I have found another fella ZeroFossilFuel, that has a very clever way of decreasing the curent usage of the HHO cell. I believe that your cell design, with his supporting electronics, will be the best marriage of these 2 technologies. I will be building my first cell in September, and hopefully, by spring, it will be perfected.

[pharbach]

Where did you get the clear plastic container shown in this video...I have been looking around for them but cant find them.....HELP!!

[pharbach]

Where do you get the clear plastic container that was shown in the video....I would like to get one......or two.....lol.....HELP!!!

[inetprez]

Can you please post a link to the plans for your cell?!?  Thanks

[kyhydrocells]

Well you don't need pressure. I use a test cap rated at 30 psi so if a flash makes it back to cell it won't hurt anyone. If you hurt PVC with heat your running your cell to hot and creating too much steam. PVC is good to about 180F.

[Mephistofeles420]

how is the SCH 40 PVC for this? I have heard it does not handle pressure and heat as well as it should, so do you think PVC is ok for the cell?