holden torana LJ 308 dyno run (porana)

this is my basically stock 308 pulling 6500rpm on the dyno. is nearly where i want it before i start building my 355 stroker. post a comment of what you think cheers check out the vids i have from a while ago. i will have some new one soon

Category:

Autos & Vehicles

Tags:

• holden
• torana
• dyno
• burnout
• car
• auto
• motorsport
• russell
• LJ
• skid
• PM

[LJTorry5000]

hey mate was it completely stock in this video or just really minor work like, overbore, extractors etc ?

[bigcannon77]

here it has std manifold, 650 d/p holley, extractors and +60 thou. everything else is std. crank, rods, pistons, heads, rockers, springs etc all std. it is the same engine now just added tunnel ram with twin carbs.

[LJTorry5000]

ohk, wat did it pull in this video at the tyres?

[bigcannon77]

unfortunately the dyno played up that day and didnt give me an accurate HP, but it gave 440Nm torque. thatks for the interest mate.

[LJTorry5000]

yeah compltely stock is rated at 427Nm, i heard somewhere that 308's sit in lj lc toranas without too much work?

[bigcannon77]

yeah steering column, engine mounts, modify sump or buy hi-volume, 253 is allowed to go straight in, 308 requires a chassis kit to be licenced.

[LJTorry5000]

oh right, cheers buddy

[bigcannon77]

ive actually got stage 3 yella terra b cast heads that im getting worked on a bit more to do the job.

[tuf73]

What heads are you going to use on the stroker?

[bigcannon77]

ive been told that i sshould expect 500hp+ its the come racing setup with twin 650 d/p holleys, the stocky has probably about 250 but im not to sure how accurate it was but it has 440n/m of torque which is quite a bit for a stocky.