HHO test3 - Update
Uploader Comments (UserName732492)
All Comments (14)
-
I have been trying stainless screen wire, it works very well, also i made spiral disc's of solder, no heat, no corrosion, no brown water, can someone afford to produce solder plates and test them i wish i could!
-
With wires inside the cell, we expect explosion after about 3 hours use. Keep wires out of the cell. All connections are to be stainless steel bolts, nuts, lock washer, tight!
-
DANGER!!!!!NO wires inside cell! NONE! you will have corrosion, and explosion. Keep wires out of the cell. DANGER...
-
your going to need a flash back arrestor.. Ebay item #250259467598
-
look at a 220 volt system nutral middle hot
on the two out side coils ..
-
yes, definitely pulse the current. perhaps @ 20k megahertz. this will drastically increase hydrogen production and lower amperage usage considerably. this is the final secret and main breakthrough for all hydrogen cell experimenters.
-
my comment is already answered as well, except for how you are twisting the steel so nicely...
my instinct would be to do two single helix with opposing spirals and polarities?
thanks again
-
Sure ! tell me where (tell me where we usually speak)
PWM will not help. Meyer used PWM to LIMIT production not increase it.
I have researched this quite a bit.
h2ofuelman 4 years ago
Not quite enough, I think...
UserName732492 4 years ago
Great! great container :-) !
hoekf 4 years ago
Thanks, they're easy to get! ;D
UserName732492 4 years ago
using linksys router for this may not be a good idea. Why not you just use the 555 timer chip and make a PWM?
seshkanuri 4 years ago
Thought a software PWM might be nice, but I don't have the skills to write a driver module for the linux kernel.. oh well, there goes this idea.
Indeed instead I'll try to make a PWM with 555 timers, as you said.
UserName732492 4 years ago