airsoft TM P90 gearbox remove and install
Loading...
4,213
Uploader Comments (recall56k)
see all
All Comments (22)
-
@recall56k oh ok thanks, i will watch it!
-
Thanks cause my air nozzle chipped. I tryed it and thanks for the video. now I just need to buy the nozzle.
-
the only thing i would worry about is if u think you will not be able to put the gear box back together. while u r in the gear box just check for wear on gear teeth and piston teeth and maby relube a little.
-
it will wear faster than a lower volt battery. just depends on quality of internals really.
Loading...
if u replace the motor do you have to replace the gears too? or better yet if u replace the motor, do you have to solar on the wires again or is plug in type no matter if its positive/negative?
SuperDwang 1 year ago
@SuperDwang if u just want to change the motor u can. U will want to mark the hot wire cuz they only go on 1 way and will short the fuse. Other wise your good to go.
recall56k 1 year ago
@recall56k dang so there not really a snap in type wire? oh well =/ guess imma have to risk it lol. thanks! can u do a video showing what to replace when u do it?
SuperDwang 1 year ago
@SuperDwang sorry, the motor plugs do just snap in no solder required. I believe I have a motor box on the p90.
recall56k 1 year ago
@recall56k ic ok so its relativily easy to replace. now i just need to memorize where the gears and springs go lol. thanks for the help!
SuperDwang 1 year ago
@SuperDwang the motor housing and gearbox are 2 different prices u will not need to mess with the gears at all. U should watch my mother replacement bid its all there.
recall56k 1 year ago