kick spindle demo.wmv
Loading...
Loading...
1,527
Loading...
Uploader Comments (MyGirlMoo)
see all
All Comments (3)
-
so how is the ball bearing in it? i want to make one and i'm ok with wood working but all the descriptions say they have bearings and i can't figure that out. did you use instructions? thanks for inspiring vid!
-
You are so innovative! Well done in making your own kick spindle. I would love one too and you prove I can! Thanks for sharing your time, talents, skills. And soft soled shoes do better than bare feet that have oils on them and would eventually stain the bottom whorl. Thanks again.
Loading...
4:46
True Creations Kick Spindleby SpindleJim2,322 views- 1:24
Spinning with my kick-spindleby sylvchezplum10,109 views
- 4:34
Homemade DIY Supported Spindleby sarahjacob200827,227 views
- 1:01
Spinning wool with kick spindle or Mother Marion spindleby knittingdragonflies3,665 views
- 3:21
kick spindleby ladyforbutch5,464 views
- 2:40
Spinning on Orenburg spindleby Vereteno22,018 views
- 55 videosD.I.Y. + crafts
- 0:30
Kick Wheelby DeJarnett9,358 views
- 6:56
Fleegle Spins on Russian Spindlesby Sglinert9,877 views
- 8:44
Spindlicity Spinning From the Foldby Spindlicity14,479 views
- 0:41
No-Cost Drop Spindleby daniellelarie429,307 views
- 2:42
Drop Spindle Tutorialby GrecoWoodcrafting335 views
- 9:57
Coloring Outside the Lines part 1A Dying fiberby Spin2Weave7,225 views
- 2:08
Spinning on the Spindolynby cadysknitvids40,251 views
- 9:21
Navajo plying on a spindleby mjspins10,034 views
- 5:59
Woollen Longdraw - for handspinningby ruthmacgregor44,315 views
- 2:56
Tammy Rizzo's Ply-on-the-fly techniqueby rosemary2000118,711 views
- 6:12
Spinning with a Navajo Spindle - Yarn 2 Spinby yarn2spin3,005 views
- 2:36
How to Dye Wool in the Microwaveby BlondeChickenYarn18,730 views
- 4:55
Spinning with a Long Drawby Spindlicity14,683 views
- 9:03
Introduction to Spinning, Part 1by afranquemont117,084 views
Hello - thanks for your comment. I didn't have specific instructions for making a kick spindle. The bearing is right at the bottom of the shaft, where it joins at the bottom. You don't actually need a bearing, you can just work the shaft into a point at the bottom and that will reduce the friction. That might even be the better way to go. I had troubles finding a bearing that was good and not expensive. Hope that helps. :)
MyGirlMoo 4 months ago