Motor tick, spun bearing
Loading...
Uploader Comments (garryjeep)
All Comments (8)
-
@SNEAKGANG Hey, my guess is I sucked some water into my set up, thinking that was it. that and some high rev's mixed in oil was still some what good when i pulled the motor apart. Some shavings but othere the that looked good pump was still working oil was still good on the gauge PSI was up there...
My guess water and high revs.. only one went as well top bearing was still on the rod and the othere three wer fine as well
-
u spun it because of no oil or a badd oil pump.
-
I have a 97 Civic LX with Over 200,000 miles on it. I beat the crap out of it on a daily basis. Runs like a charm.
-
i give it 2 miles
-
Still running on all four pots by the sound of it. What was it, little end bearing, top end / cams?
-
rods busted same problem happened 2 my ride
1:09
ls1 spun bearingby avexhype18,632 views- 0:39
B16a spun rod bearing?by LIV3TOKILL17,558 views
- 0:24
Spun Bearing??by pauliss0710,349 views
- 1:34
3000gt lifter tick or spun bearingby 3kgt00712,753 views
- 0:21
Valve Tickby preludedriva16,093 views
- 0:31
Honda Civic D16Y8 knocking soundby OP1009,956 views
- 1:38
Spun Bearingby blt4rox25,258 views
- 0:22
Dave mirra's STI Spun a Rod Bearingby ffxbb621,895 views
- 1:52
How do I install a piston rod bearingby mikeyidh44,348 views
- 1:03
Engine ticking noise #1by kidsamston17,647 views
- 0:50
engine tickingby vinboy12324,839 views
- 0:24
What is this noise? did I spin a rod bearing?by wutthe55558,333 views
- 3:14
2.7L chrysler sebring engine spun bearing foundby 905speedgta13,146 views
- 0:21
Lifter Noiseby cgbaseball2390,550 views
- 0:48
2002 Mustang GT Spun Rod Bearingby hemicuda3327,247 views
- 1:02
Spun Rod Bearing 4G63 turbocharged engine.by talon4wd5,595 views
- 0:45
Guess this engine sound....by holdmedown4009,694 views
- 0:45
2000 Honda Civic engine problemby doubleclutch7933,865 views
- 0:31
1985 Honda CRX Wrist Pin Tick/Knockby pilotguy874,681 views
D16Y7?
wootness3000 10 months ago
@wootness3000 Yes it was a D16Y7 with a turbo kit.
this video was shot after the car had gave up on me.
It was still running on all 4 and would start first key !!! It was the bearing on the crank
it let go and the sound you hear is the ROD moving side to side becasue the bearing is gone.
took it all apart, ROD was bent and bearing was gone but fouund it in my oil pump as it was shavings.
Put a new $350 wrecker motor in it. and off we went for round two.. good little cars.
garryjeep 10 months ago