Eric's 2004 SVT Cobra with Ported Eaton 495 hp
Loading...
Uploader Comments (liedenfrost)
All Comments (33)
-
So sexy :)
-
@liedenfrost Ah, alright. Cause I put a pulley on mine (2.81") with K&N Cold Air, X-Pipe with Hi-Flo Cats and a catback and I figured I'd be looking somewhere in the range of 460rwhp? Least judging by the other videos I've watched with Cobras with similar upgrades. I don't have the money at the moment to get her dyno'd, so I'm going off of pure estimation.
-
skeeeeeeeeeeeeeeeeeeeeeeet!
-
@cafeevil yes he is full of shit. he needs full exhaust, every single bolt on plus he would need to run 17psi.
-
how do you take off the supercharger ?
-
He does have the double pulleys, I dont know about the LT headers though. I know that onthe street he got into it and when I did I was immeadiatly pulling up to him. I was thinking uncorrected as well he never mentioned the TB. and it was a SCT tune from HORSEPOWER HERMAN.
1:04
2003 Cobra with Ported Eaton and Kooks LTsby EFILogics4,516 views- 0:52
2003 Cobra 825 rwhp & 757 rwtq - Tuned by RWTDby RWTDdotcom10,355 views
- 1:38
'03 Ported Cobra 2Stepby rpk201264,363 views
- 0:29
Snakebite (Ported Eaton) Powered '03 Cobraby Sweet83GT9,649 views
- 1:57
Smoke em if ya got em!by AzMz6182,911 views
- 0:56
Posi Ported Eaton no nitrous 03 Cobra 10.15@136by Joe2003cobra4,925 views
- 0:10
SVT Cobra Listen To The Kenne Bellby bobmychode295,678 views
- 0:33
How to merge onto the highwayby Linktheworld76,553 views
- 0:15
03 Procharged Mustang Cobra on Dynoby brownbrosparts3,633 views
- 2:57
CobraStrucks 04 Cobraby CobraStruck3,023 views
- 0:07
Cobra leaving Stealth Autoby StealthAuto137,437 views
- 0:42
500 HP dyno pull in my 04 SVT COBRAby NERDKILLER16,168 views
- 0:14
Ported eaton cobraby 03wetsnake8,577 views
- 0:08
Ported Eaton Blower Whineby balexwogel5,077 views
- 0:58
03 kb cobra vs 04 pulley & ported blower cobraby SALEENGTROUSH8,910 views
- 1:01
Ramon 240 vs. 03 Cobraby blwn03cobra19,148 views
- 1:21
Procharged Z06 vs Ported Eaton Cobra vs 2005 GSX-R 600by 20TooSlow12,959 views
- 0:44
04 Cobra at the track.by NateSVT26,224 views
- 3:03
04 Kenne Bell Cobra (fly-bys, rev, and wot pass) Borla Stingers / Bassani offroad X pipeby agc612603,166 views
495hp with a ported blower? ...That's...very conservative...have you even done a pulley swap at this point? Why so low a number?
veritech102 1 year ago
@veritech102 The numbers are in line with a single upper pulley setup with 21 degrees of timing. The numbers are with the stock TB and stock midpipe including all 4 cats. I have since replaced the stock midpipe with a magnaflow midpipe (only two high flow cats, rather than 4), so I'm likely in the 505 - 510 rwhp range now.
liedenfrost 1 year ago
I have a friens who said with his pullied cobra with a CAI and a ported SC at 15psi he is laying down 554rwhp on a dynojet 2 something. Is he full of shit or was it just uncorrected hp tq numbers,,, It seems a bit high to me for so few mods and people on here are not even breating into the 500's with the same set up. I let him have his moment though.
cafeevil 2 years ago
I have a very conservative tune and only a cat-back exhaust. I could easily pick up 20 rwhp or so by uncorking the exhaust. Not likely 554 rwhp unless its uncorrected. Does he have full exhaust, double pulley, headers, ported intake and throttle body? Maybe.....554.
liedenfrost 2 years ago