Eco-8-0005 Aerobatic/3D Video
Loading...
Loading...
6,074
Loading...
Uploaded by ChachinRC on May 17, 2007
Getting my Eco-8 dialed in for aerobatic flight.
Uploader Comments (ChachinRC)
see all
All Comments (8)
-
I wish I can get an autorotation gear and bearing for my Kalt Whisper.
-
where did you get that alu stuff ?
-
haha thats awesome flying man. How much was your battery and ESC?
-
Good vid. Clean flying. Nicely "blinged out" ECO. Working on getting mine there, too many hobbies.
-
Greatest landing, and Best Tune.
One of the gang @ RcGroup
-
great flyin!!!
Loading...
100 videosYouTube Mix for Lenny Kravitz- 5:25
ikarus eco8 test in stockholm 1999by jostraka2,979 views
- 2:16
Eco 8by sachap113,034 views
- 1:23
ECO 8 Swash Plate Travelby Spidious4,077 views
- 4:29
EC-135 SMALL GARDEN, BIG WIND!by GAZZERPOPE552,834 views
- 0:51
Eco 8 Haute vibrationby braguetor2,324 views
- 1:18
Eco 8 final demoby Artemetra1,396 views
- 0:48
Eco 7 First crashby EcoFlieger8,107 views
- 0:22
None (Video-0005.mpeg)by ALAIDLER19873,108 views
- 6:41
Eco7 Jet Rangerby xboeffx7,342 views
- 1:31
Ikarus Eco 8 RC Helicopterby BARIQco15,174 views
- 6:43
raptor 90 Alan Szabo jrby chinopatata105,021 views
- 0:54
MD-500 Shogun V1 - Scale Masterby nyturtle134,271 views
- 5:57
Flying under Stockholmby henke2630,683 views
- 1:29
Hubschrauber Heli Crashby patrickmerkur208,264 views
- 5:45
RC-Helicopter-flight Eco 8 Royalby Unterbauer10,791 views
- 0:57
BO 105 SOBRE ECO 8by aerovoltio2,321 views
- 2:26
On board video from my Eco 8 Royalby tahustvedt937 views
- 0:54
Hughes 500E - ECO 8 4 Main Bladesby Spidious2,074 views
- 6:07
ECO8by jamesotron2,095 views
- 6:26
Bell 222 Eco 8 Flybarless Helicommand Rigid inverted 3by tomgrund11,815 views
was that a autorotation landing? I noticed you had the tail spinning so you must of had a little throttle input
FordManMT 2 years ago
Hello, yes it was a true autorotation (no throttle input). I guess the tail rotor sometimes "sticks" and takes a while for it to come to a complete stop. It also happens with my non-tail driven Logo10 and 24.
ChachinRC 2 years ago
Would you provide your setup?
Thanks
llamont123 4 years ago
Sure. In this video I'm using a Kontronik FUN600-18 motor, Kontronik Beat 55-6-18, geared for 1950rpm, S3102 servos, 401/9254 for the tail, and a 4S3P 6000mAh ProLite from ThunderPower. Oh yeah, and A LOT of upgrades :).
ChachinRC 4 years ago