Patching, Filling & Grinding Your Concrete- Patching & Repairing Your Concrete

PATCHING, FILLING & GRINDING
Patching & Repairing Your Concrete

What You Need:
•Jiffy Mixer or Putty Knife
•Broom or Shop-Vac
•Hand Grinder or sander
•Latex Protective Gloves
•Small Mixing Container
•Self-Leveling Sealant or Patching Compound
Filling in divots, pits and cracks is an optional step. Hairline cracks will be filled in with the primer epoxy and do not require special attention unless the crack is wide or deep. Patch all pits and cracks by utilizing a concrete patching compound.
Use a self-leveling sealant, which is also a flexible coating, to fill in expansion joints. This is an optional step based on your personal preference. Please clean and remove all debris from the expansion joints before applying.

It is extremely difficult to completely hide an expansion joint; therefore it is recommended to fill it in as much as you can. Applying this also allows the concrete to move without cracking it. Fillers must dry overnight before applying any coatings.
To repair your cracks and divots, use Norcrete Crack Filler. This two component 100% solids epoxy crack filler is designed for shallow repair on either vertical or horizontal surfaces. This product is easy to mix and use and has a non-critical mix ratio. Additionally, because it is a 100% solids formulation, it can be applied thicker on horizontal surfaces when required.

This product has a mix ratio of 1 part A to 1 part B by volume. To mix, simply measure out equal volumes of the material and mix them together thoroughly with slow speed mixing equipment such as a jiffy mixer, putty knife until the material is thoroughly mixed and uniform in color. Mix only an amount of material that can be used in the allotted pot life period. Improper or insufficient mixing may result in product failure.
If you are having a hard time spreading the compound because of its thick consistency, dip your putty knife in a xylene solution and spread the patching compound. Zylene is a thinning agent and will help smooth out the consistency for easier application.
Here is another trick to get the patching compound as even and level to the surface as possible. Dip a paintbrush in some Xylene and brush it over the patched area to smooth the surface.
After you have patched the surface and waited the appropriate cure time, you can now begin to grind the surface. By grinding the patched areas, you will be leveling the surface of your concrete. This creates a seamless surface so you will no longer see the patched areas once you apply the coating.

Category:

Howto & Style

Tags:

• original color chips
• concrete patching
• filling pits and divots
• crack filling tutorial
• epoxy flooring
• cobalt party revolution