Hydrogen at home (configuration test unit)#35
Loading...
Loading...
423
views
Loading...
6:06
Allison watches Pat's 4Runner rev on 100% HHO for a few seconds.by Javadavida25,892 views- 5:20
hho torch making glass from sand by h2extreme.comby woodypc35115,183 views
- 6:32
Pat puts a stop watch to Dr. Steve Eaton's 12v HHO cell.by Javadavida16,167 views
- 6:33
130 volt Hydrogen generator using 120v ac house power.by delvis1136,749 views
- 2:31
Run a torch, car, truck, heat, fuel on water. 100% Hydrogen energy HHOby powerzap6927,536 views
- 4:50
Hydrogen at home (New power supply)#30by markj301,602 views
- 7:46
coil driver 2by irondmax493 views
- 0:07
hydrogen storage tankby myrcjunkyard87,977 views
- 2:52
New Hydrogen-Storage Method Discoveredby CarnegieInstitution2,703 views
- 0:21
PEM Electrolyser, Fuel Cell 1kW & H2 Storage Tankby tropicalgreentech17,115 views
- 8:57
Hydrogen at home (Mud problem revealed)#29by markj303,006 views
- 9:00
Hydrogen at home (parallel vs series)#32by markj303,803 views
- 10:21
Hydrogen HHO Nickel 7 plate zero current leakage cell EFFICIENCYby delvis115,964 views
- 2:25
HHO like you've never seen before!by jab0805667 views
- 8:39
Hydrogen at home (new Stick cell part 1)#24by markj301,408 views
- 6:49
12 volt power supply for HHo generatorby Iseekoutthetruth2,151 views
- 5:04
HOW NEUTRAL PLATES WORKby cyberscann546,765 views
- 7:14
making hydrogen with magnets and resonanceby advancedhydrogen13,055 views
- 5:36
Hydrogen at home (new cube cell)#16by markj303,988 views
- 3:37
Hydrogen HHO production at very low volts..wmvby delvis1111,947 views
It seems like you are not separating hydrogen and oxygen.. so that is not Hydrogen you get out since you take the gasses from both the anode and kathode....
taztaz79 3 months ago
Thanks for that. After watching some of your videos I noticed that one of the units mixes the returned fluid together at the bottom intake and another unit keeps them isolated. What differences did you find between the two designs? Also I see that you are using about 2.8V per gap which seems a little bit high. Are you doing this in order to achieve enough consumption of amps? What is your average MMW?
markj30 1 year ago
Are you referring to the twin gasket and membrane method? If so how do you find its effects on efficiency (MMW and gas output LPM). Do you find it requires a much higher electrolyte concentration in order to produce the same amount?
Thanks for your input.
markj30 1 year ago