Belt cp main gear swap
Loading...
Loading...
16,038
Loading...
Uploaded by Ber60beltcp on Apr 5, 2008
swap main gear
Uploader Comments (Ber60beltcp)
see all
All Comments (9)
-
I change it 5 times XD
-
Hi TeddyBakesher
It means that the one-way bearing in the main gear is fitted wrong or that the main gear is upside down or bad meshing between motor and main gear
-
Hi, I just replaced the main gear, but when I spin up the engine the motor starts and goes but the rotors wont go.. The motor is just spinning. What did I do wrong?
Greeting from Norway
-
it was very usefull for me! (the part about testing the oneway position) thanks a lot!
Loading...
6:01
E-Sky Belt CP Direct servo to swash plate modby spooky1i200214,612 views- 3:53
Belt CP DTS modificationby ianturner138,528 views
- 0:47
Belt cp directionby Ber60beltcp10,260 views
- 0:42
Belt CP Getriebeby hflheli6,929 views
- 6:58
Zero pitch on a flybarless helicopter using a pitch gaugeby Rototerrier8,767 views
- 4:12
Esky Belt CP 6CH 3D RC Remote Control Helicopter CCPM EK1H-Eby toysonics366,252 views
- 2:07
BIG CRASH BELT CPby crazy9catears39,995 views
- 2:35
Belt CP : GROS CRASH N°2 DANS LES ARBRES!!!!!!! :-(by yohoneybee278,468 views
- 7:19
Setting up and reading pitch on a Belt CP helicopterby Painless36025,713 views
- 2:21
a simple way to make my control shaft mod near perfectby crazy9catears15,554 views
- 6:50
belt cp big crashby orenoved28,368 views
- 5:31
ESky Belt CPX - Set up part 3by nuttcaze16,505 views
- 2:35
Belt CP V2 - Matty Heli Crash #1by DavidandMatty11,491 views
- 0:07
belt cp blade tracking good setup blades in trackby jurikristjouw8,443 views
- 3:56
Belt CP fly bar mod - 2by ianturner138,803 views
- 2:01
Esky Belt CP V2 hover training and test flight after crashby stevenmoody198357,233 views
- 9:08
First crash outsideby tingchris17,500 views
- 1:55
carbon canopy 450 rex carbon blades belt cpby crazy9catears27,225 views
- 1:17
Unpredictable Belt CPby LyfeLangmead34,617 views
- 3:59
HK450 Build 3 Main gear mast installby rcalvarocr18,850 views
what do you put the pinchers into?
EF247 3 years ago
In a vise or a clamp
Ber60beltcp 3 years ago
hi
how do you remover the one way bearing?
thanks
EF247 3 years ago
You have to push it out in a vise, if you do a search on helifreak you will find a explanation with pics
Ber60beltcp 3 years ago
cheers
what tools do you need to remove the gear?
EF247 3 years ago
a hex nut of 10 at one side and a hex nut a bit smaller then the bearing to push it out in to the 10 hex nut
I hope this is still readable
Ber60beltcp 3 years ago